Idiomas disponibles
Idiomas disponibles
Diagram 2
Side
Handrail
Rear
Handrail
C
Bar
HANDRAILS
NOTE: DO NOT tighten bolts until instructed to.
1.
With ladder on its side, install left handrail (A) into the
rear stile tubes. Use the rubber mallet as needed for
mating parts. (See Diagram 1)
2. Clamp side handrails to outside of stile tubes using
detached handrail brackets and 3/8-16 x 2" hex
head cap screws, gray bushings and self-locking
nuts. (See Diagram 2, Step 2)
3. Repeat step 3 with right handrail (B).
HANDRAIL EXTENSION PANELS
1.
Install the handrail extension panels (J) into support
tubes located on the sides of the platform.
(See Diagram 2, Step 3)
2. Clamp handrail extension panel to handrail panels
using extension clamps and 3/8-16 x 2" hex head cap
screws & self-locking nuts. (See Diagram 2, Step 4)
PAGE 3 OF 9
ASSEMBLY CONTINUED
1/4-20 x 2¾"
H.H.C.S.
Handrail
Extension
Clamps
3/8-16 x 2"
H.H.C.S.
Step 4
Step 5
Notched
Bushing
J
Support
Tube
Handrail
Bracket
Step 3
3/8-16
Self-locking
Nut
Tube Cap
Handrail
Rear Stile Tube
Step 1
A, B
D
REAR HANDRAIL BARS
1.
Detach rear handrail bar (C) from handrail or
extension panel.
2. Insert notched bushing into each end of rear
handrail bars (C). (See Diagram 2, Step 5)
3. Position rear handrail bars between mounting holes
on the top part of side handrails using four 1/4-20 x
2¾" hex head cap screws.
NOTE: You may now tighten all handrail bolts.
LEVELING
1.
Stand ladder upright on level surface.
2. Activate safelock by stepping on the trip bar
located in front of the first step.
3. This sets the ladder on the feet to level.
4. When steps are level, tighten all installed bolts.
NOTE: DO NOT proceed until ladder is stable.
1-800-295-5510
uline.com
Stile
Handrail
Tubes
Bracket
3/8-16
Self-locking
Nut
Step 2
Gray
Bushing
3/8-16 x 2"
H.H.C.S.
1123 IH-3133U-24
