Idiomas disponibles
Idiomas disponibles
EN
11. DO NOT connect water supply to a hot water supply. Verify that inlet water temperature is between
3~35°C/37.4~95°F.
12. Raise the room temperature to prevent the toilet from damage due to freezing.
13. When not using the product over three (3) days, drain the water out of the toilet and pull the electrical
plug from the wall electrical outlet.
14. Stop using the product and shut off the power when product malfunctions. Call for professional service.
15. If this product is installed without a power plug, a power circuit breaker should be connected in series
in the power input loop of the same room where the product is installed to verify safe use.
16. If this product is installed without a power plug, a switch device capable of disconnecting the power
supply of this product must be installed in the front end of the wiring.
17. The product MUST NOT be used at an altitude of more than 2000 m as there will be current leakage
risk.
GROUNDING INSTRUCTIONS
This product MUST be grounded. In the event of an electrical short circuit, grounding reduces the risk of
electric shock by providing an escape wire for the electrical current.
The plug MUST be plugged into an electrical outlet that is properly installed and grounded.
DANGER – Improper use of the grounding plug can result in a risk of electric shock.
If repair or replacement of the cord or plug is necessary, do not connect the grounding wire to either flat-
head terminal.
Check with a qualified electrician or serviceman if the grounding wire instructions are not completely
understood, or if in doubt whether the product is properly grounded.
This product is factory equipped with a specific electric cord and plug to permit connection to a proper
electric circuit. Verify that the product is connected to an electrical outlet having the same configuration as
the plug. No adapter should be used with this product.
DO NOT modify the plug provided. If plug does not fit the electrical outlet, please have the proper electrical
outlet installed by a qualified electrician. If the product must be reconnected for use on a different type of
electric circuit, the reconnection should be made by qualified service personnel.
4
