Idiomas disponibles
Idiomas disponibles
STEP 5
Connect the hose connector to the pressure washer. Before connecting
the connector to the male connector, remove the plastic cap that is
inserted into the male connector of the pressure washer prior to
shipment. This plastic cap can be discarded once removed. Once both
components are installed, connect the Garden Hose with the Connector
Screw to the Pressure Washer. Connect the garden hose to the water
inlet.
STEP 6
If connected to a non-pressurised water supply, the water supply must
not be more than 50cm below the water inlet of the machine.
If the water source is at a higher elevation than the machine inlet, the
water surface must not exceed 50cm to the top of the water container. At
this point, the sprinkler cannot be installed. After starting the machine,
wait for the water to flow from the gun head and then connect the nozzle
for use.
It is important to ensure that the elevation of the water source is
adequate before installing and using the sprayer, and to follow this
procedure to avoid operational problems.
INSTRUCTIONS FOR USE
START-UP
After connecting the pressure washer to the cold water supply, proceed
as follows:
Instruction manual
▶Make sure that the ON/OFF switch is in the OFF position.
▶Connect the garden hose to the inlet connector.
▶Install the handle and fixing plate to the main body of the machine,
▶Insert the adjustable spray nozzle into the gun according to assembly
▶Connect the high pressure hose to the high pressure outlet connector
▶Connect the high pressure hose to the gun, according to assembly
▶Connect the garden hose to the inlet connector of the high pressure
▶Fully open the water supply valve.
▶Before turning the unit on, press the gun trigger to bleed any
▶Turn the pressure washer on by turning the on/off switch to the on
AUTOMATIC ON/OFF
The pressure washer is equipped with an automatic on/off switch. The
pressure washer will only operate when the power switch is in the ON
position and the gun trigger is pulled. When you release the trigger to
stop spraying water through the gun, the pressure washer motor will
automatically shut off. Simply pull the trigger again to continue using
the cleaner. To stop using the pressure washer, release the trigger and
switch the unit to the OFF position. The unit should be completely shut
off when not in use or unattended.
PURGING THE GUN
It is very important to purge the gun before using the pressure washer.
Refer to the "Assembly Instructions" to assemble the pressure washer.
To purge the gun, simply connect the garden hose to the pressure washer
and pull the trigger before turning on the power supply. This allows air
trapped inside the pressure washer and gun to be removed before using
the unit. Continue to squeeze the trigger for approximately one minute
21
as per assembly step #1.
step #2.
according to assembly step no. 3.
step no. 4.
washer according to assembly step no. 5.
remaining air from the pump and hose.
position and squeezing the trigger. Reminder: The motor does not run
continuously, only when the trigger is pulled.
WARNING: INJECTION RISK! The unit will start spraying
when the trigger is pulled. When the unit is turned off
after use, there is still high pressure inside the hose and
unit. Point the gun in a safe direction and discharge excess
pressure.Never direct the high pressure water jet at people
or animals.
ref. 08470
ES
PT
EN
FR
