Settings; Enter Setup State; Delay Arm - Smanos WK8000 Manual De Funcionamiento

EN

Settings

The keypad should enter setup state before all settings.

Enter Setup State

Input [admin code + #] to wake up keypad.
Press [3] to enter setup state, the LED indicator is on.
Under setup state, if there is no operation within 10 seconds, the keypad will exit
setup state automatically. Or you can press
9
[#] to exit.

Delay Arm

When the alarm system is armed, detectors will start working
immediately. If you are at home during the time, an alarm will be
triggered. After setting delay arm, press
arm signal will be sent to the control panel after the set time.
If the control panel and the keypad both set a delay time, the actual delay time is
the total of both times.
Delay Arm
2 delay time
Enter setup state, input:
When one beep is heard and the LED indicator keeps on for
10 seconds, the setup is successful.
Once the delay time is set, when you arm the keypad, it will beep once every
two seconds to remind you to leave. The reminding rhythm will speed up in the last
15 seconds. After the delay time, the control panel enters arm state.
Note: User can input digital 0-250 which refers to 0-250 seconds. Default
setting: 0, no delay.
EN
on the keypad, the
10