Idiomas disponibles
Idiomas disponibles
Assembling
Hose Reel
IMPORTANT:
You must take the hose off the reel
when operating your pressure washer. The reel is for
storage purposes only.
•
Attach the handle to the reel with Iocknuts, flat
washers, and bolts. Please note that the bolts are
inserted with their heads inside the hose reel.
Hose reel
Handle
Locknut
Flat washer
Bolt
Secure the hose reel on the handle, at the location
shown on page 7 with Iocknuts and bolts.
Clamp
Locknut
/
Screw
Hose Clip
Bolt
•
Attach the spring clip with a black self tapping
screw in the hole provided on the clamp.
NOTE: There may be some hardware included with
the hose reel kit that is not used on this model.
Add Engine
Oil
IMPORTANT: Any attempt to crank or start the engine
before it has been properly serviced with the
recommended
oil may result in an engine failure.
NOTE: When adding oil to the engine crankcase, use
only high quality detergent oil rated with API service
classification SF, SG, SH, SJ or higher rated SAE 30
weight. Do Not use special additives.
•
Choose a viscosity according to the table below:
Uo r rl_I(
4
F
-20
0
20
32
40
60
80
100
'C
-30'
-20'
-10
_
10
20
30
40
STARTING
TEMPERATURE
RANGE
ANTICIPATED
BEFORE
NEXT
OIL CHANGE
* The use of multi-viscosity oils (5W-30, 10W-30, etc.)
in temperatures
above 40°F (4°C) will result in higher
than normal oil consumption.
When using a multi-
viscosity oil, check oil more frequently.
** If using SAE 30 oil in temperatures
below 40°F
(4°C), it will result in hard starting and possible
engine bore damage due to inadequate lubrication.
•
Place pressure washer on a level surface.
•
Clean area around oil fill.
•
Remove oil fill cap.
•
Pour oil slowly. Fill to the point of overflowing.
•
Replace oil fill cap, tighten securely.
NOTE: Check oil often during engine break-in.
Add Gasoline
_
ARNING!
Never fill fuel tank indoors. Never
fill fuel tank when engine is running or hot. Do
Not smoke when filling fuel tank.
,_
WARNING!
Never fill fuel tank completely full.
Provide space for fuel expansion. Wipe away
any fuel spillage from engine and equipment
and let residue evaporate before starting.
•
Use fresh, clean unleaded automotive gasoline and
store in approved, clean, covered containers. Use
clean fill funnels. Never use "stale" gasoline left
over from last season or gasoline stored for long
periods.
•
Clean area around fuel fill cap, remove cap.
•
Slowly add gasoline to fuel tank. Use a funnel to
prevent spillage. Fill tank to about 1.5" below top of
the filler neck to allow for fuel expansion.
_'_.
_
r-Tank
•
Install fuel cap and wipe up any spilled gasoline.
