Idiomas disponibles
Idiomas disponibles
TROUBLESHOOTING
PROBLEM
POSSIBLE CAUSE
<
> is on
Lack of water
<
> is on
The water
reservoir has
Too much ice
water, but <
>
cube in the basket
is on
The inlet solenoid
valve breakdown
The ice making
system damage
<E> is on
Too much water
in the ice basket
<E1> is on
Ambient temp
sensor breakdown
<E2> is on
Water temp sensor
breakdown
<F> is on
The ice full plate
blocked
No water in the
The holes are
water separator
blocked
pipe
Water filter block
14
SOLUTION
Turn off the unit and add
water to <FULL> level,
then re-start the unit.
Remove the ice cube in
the basket.
Need the technical
service person to
maintain.
Need the technical
service person to
maintain.
Drain out the water
below the ice basket,
and then turn on the unit.
The unit can still work,
change a new sensor
The unit can still work,
change a new sensor
Take out the ice cube
under the ice full plate,
make sure the ice full
plate can roll smoothly.
Or wait 2-4 hours until
the ice cube melt and
the ice full plate roll
back automatically.
Use slim wire to prick
each hole, till The water
can flow out easily.
Clean the water filter
Ice cube thick and
Ice making cycle
can't drop down
too long
Ice cube thin
Ambient temp too
high
Water temp too high The water temp should
Ice making short
Unit work but no
Ambient temp is
ice cube
high or the water
temp is high
Refrigerant system
leakage
Refrigerant
system block
TECHNICAL PARAMETERS & CIRCUIT DIAGRAM
TECHNICAL PARAMETERS
Model
Protection Type
Power
Ice Making Current
Ice Harvest Current
Refrigerant
Enclosure
Press <->to reduce the
ice making time.
Move the unit to cool
place
be no more more than
25℃（77℉) .
Press <+> to increase
the ice making time.
Move the unit to
somewhere ambient
temp lower than 30℃(86
℉ ), fill cool water.
Need the qualified
technician to maintain
Need the technical
qualified technician to
maintain
EP24525DE
I
220-240V 50Hz
1.1 A
1.3 A
R290
32g
Stainless
15
