Idiomas disponibles
Idiomas disponibles
CLEANING AND MAINTAINING YOUR ICE MAKER
Before using your ice maker, it is strongly recommended to
clean it thoroughly.
1. Take out the ice basket.
2. Clean the interior with diluted detergent, warm water and a soft
cloth.
3. Then use the water to rinse the inside parts, and drain out the
water from the draining port by unplugging the drain cap on the
back.
4. The outside of the ice maker should be cleaned regularly with a
mild detergent solution and warm water.
5. Dry the interior and exterior with a soft cloth.
6. When the machine is not in use for a long time, open the water
drain cap to drain water completely out from the water reservoir.
After using your ice maker for a long time, we also suggest you
should clean your unit. Especially to the water separator pipe and
the water filters, you must clean them periodically.
1. If the water separator pipe is blocked and there is no water
flowing down when you listen the compressor and the water pump
inside are still working, please turn off the unit first and disassemble
this pipe down, and clean it. Clean the each hole on the pipe wall
displayed in following picture. After cleaning, install back the water
separator pipe and be sure the right terminal of the pipe connect to
the silicone pipe well and as original.
10
Water Separator Pipe
Hole
Evaporator
2. For both of the water tank and the big water reservoir, clean them
with diluted detergent, warm water and a soft cloth. Then use the
water to rinse the inside, and drain out the water from the draining
port by unplugging the drain cap on the back. It will help you keep
the unit and ice-cube hygienic, and also make the unit work
normally.
3. When cleaning, if find that the ice cube left on the evaporator and
can not be taken out easily, you can turn on the unit to let the unit
enter the ice making process, then press "ON/OFF" button for more
than 5 seconds to let the unit start ice harvest process to melt the ice
cube. It will help you remove the hard ice cube.
How to drain out the water from the internal tank and big
water reservoir completely
Because the water in the big water reservoir is stop to drain port by
the water valve, if you want to drain away all the water, please plug
on the unit and but don't start the unit, then remove the drain port
cap at the back. Wait some minutes, all of the water will flow out.
USING YOURICE MAKER
Operation panel and display area
1. Remove the cover of the water reservoir and pour potable water
into water reservoir. And be sure to keep water level below the max.
level with FULL mark displayed in following picture. Then move back
the cover at once to avoid foreign matter enter.
DISPLAY AREA
OPERATION AREA
11
