Measure Pressure Peaks/Display Full Scale Value; Delete Min/Max Values - Parker ServiceJunior SCJN Serie Instrucciones De Manejo

4.5

Measure pressure peaks/display full scale value

■
The MIN/MAX function is used to measure pressure peaks.
■
The display of the full scale value (FS) helps make the bar graph
function easier to read.
The smallest (MIN) or the largest (MAX) measured values are stored
in the MIN/MAX memory. The MIN/MAX memory is deleted when the
device is switched off. If different pressure tests are to be carried out in
succession, the MIN/MAX memory must be deleted after each meas-
urement.
1
Press the MIN/MAX/FS key to switch between the display
values.
ª The currently selected display value (MIN, MAX or FS) is
shown on the display.
4.6

Delete MIN/MAX values

1
Press the RESET/OK/START-STOP key.
ª The MIN and MAX values are reset.
V1.0/01/20
Operation
19