poolstar HOLL'S Gaia Luna Manual De Instalación página 16

Maintenance & servicing
Protection of wood
Brush each exterior barrel slat and apply a wood stain when full assembly to protect the wood.
This wood stain had to be renewed according to the recommendations of the product used
Maintenance
IMPORTANT Disconnect the cabin's power supply cable before undertaking any work.
:
Problems identified
Electric stove does not
heat up.
Sauna light fitting no
longer work.
Servicing
1. Disconnect your sauna.
2. Use a vacuum cleaner to remove dust from crevices in the woodwork.
3. Clean the cabin with a damp cotton cloth and use a small amount of soap if necessary. Rinse with a damp cloth.
4. Clean the glass with a window / glass cleaner and a soft colth.
5. Maintain the exterior of the sauna every 2 years with a suitable product.
IMPORTANT
:
The wood should be treated with a protective product only on the outside of the sauna.
No treatment should be applied inside the sauna.
Do not use benzene, alcohol, chemical agents or strong detergents on the sauna since chemical
products can damage the wood. Do not spray water on your sauna.
14
Possible reasons
Power supply cable disconnec-
ted.
The general power supply is cut.
Stove is overheat protected.
Light cable not fully plug.
Light is defective.
Solutions
Check power supply cable connection.
Check that the switchboard and wall plug are
working.
Refer to the electric stove manual.
Plug the cable.
Contact your dealer.