Idiomas disponibles
Idiomas disponibles
ENGLISH
not place the refrigerator in a damp place to avoid rust or loss of cooling performance, and do
not expose it to rain.
Please note
The amount of refrigerant used by the refrigerator is specified on the appliance marking.
2. Installation instructions
Before installation, please read the instructions carefully to avoid any problems.
-
Figure 2 shows the dimensions of the mounting space.
-
-
Place the refrigerator on a solid, flat surface to keep it stable, otherwise vibrations and
noises will occur. When the refrigerator is placed on a carpet, straw mat, or polyvinyl
chloride, solid support plates should be placed under the refrigerator to avoid colour
change due to heat dissipation.
It is necessary to maintain unobstructed ventilation around the appliance or in the
-
structure where it is installed .
3. Reversing the refrigerator door
The opening side of the door can be changed from the right side to the left side if the
-
location of the appliance requires it.
Warning! Be careful when reversing the door.
-
-
The appliance must not be connected to a mains socket. Make sure it is unplugged from
the power supply.
Necessary tools (not included).
-
a. Crosshead screwdriver.
b. Flat-head screwdriver.
Fixed spanner 8 mm.
c.
NOTE: When necessary, tilt the refrigerator backwards to gain access to the base, the appliance
should be placed on soft foam packaging or similar material to avoid damaging the back of the
refrigerator. To reverse the door, the following steps are generally recommended.
1. Place the refrigerator in an upright position. Open the door and remove the top hinge
protector (left and right). Remove the bottom screw hole protector from the refrigerator.
Remove the door screw hole protector (Fig. 3).
2. With the door closed, remove the screws on the outside of the hinges. Open the door
hinges. With the hinge open, loosen the screws securing it to the refrigerator. Be careful
with the hinge, use a long shaft screwdriver if possible (Fig.4).
3. Remove the hinge and place it in the diagonally opposite corner of the refrigerator. Screw
it back on. Repeat with the other hinge. Refit the door and refasten the hinges. Check that
the door is aligned horizontally and vertically and that the seals are closed and securely in
place on all sides before tightening the bottom hinge screws (Fig. 5).
52
BOLERO COOLMARKET TT BI 138 E
