Zipper 912003923836 4 Manual De Instrucciones página 21

Fig. P
o Connect the dust collector plug of the protective cap 20 and the dust collector plug 14
with the hose 21. Then stick the hose into the hose clip.
Fig. Q
o Now use 2 screws M6x20 to connect the fence 23 with the part 24.
Fig. R
o Push the assemble part into the chamfer of the guide.
Fig. S
o Using 2 screws M6, fix the part 25 on the foot 3.
Fig. T
o Now mount the parts of the handle 26, 27, 28 on the feet 2 and 3 by using 4 six-head
screws M6x16 and the related nuts and flat washers.
Fig. U
o Now control whether the machine looks like the machine on the picture.
5 Operation instructions
Placement of the machine (Fig. V)
For changing the place you have to use the wheels. By lifting the machine at the handles, the
machine is very easy moved. Regard that the floor is planar.
Starting/Stopping (Fig. 1)
Pushing the switch 34, the machine is turned on. It gets turned off by using switch 33.
Adjustment of the blade depth (Fig. 2)
Always adjust the blade depth so, that the top of the saw blade is about 2-3 cm over the work
piece. It is adjusted by the hand wheel 35. You can read the height of the saw blade on the
scale 36.
Adjustment of the blade tilt (Fig. 3 und 4)
For tilted cuts you have to open the lock screw 39. Then you have to open the second lock
screw 38. The tilt can now be adjusted and read on the scale 37. Then the two lock screws
have to be fixed again.
Adjustment of the fence (Fig. 5)
Angular adjustment: At first you have to open the lock screw 40. The angle can be read on the
scale 41. For the most important angles there are grooves. Using the detent 43 these angles
can be adjusted easily. After the adjusting the lock screw must be fixed again.
Adjustment of the distance to the saw blade: Move the fence to the wished measure which can
be read on the scale 44.
21