Methods Of Operation; Testing The Tool - Interchange NSJH64-34 Manual Del Operador

NSJH38-34 and NSJH64-34
12
Correct
placement
of nail
Incorrect
placement
of nail
ƒ Disconnect air hose from the tool.
ƒ Remove all fasteners from the tool.
ƒ ALL SCREWS MUST BE TIGHTENED.
ƒ If any screws are loose, tighten them.
ƒ THE SAFETY/PUSH LEVER AND TRIGGER MUST
ƒ Adjust the air pressure to 70psi.
ƒ Connect the air hose.
ƒ Do not load any fasteners in the tool.
ƒ THE TOOL MUST NOT LEAK AIR.
ƒ Remove finger from the trigger and press the safety/
ƒ THE TOOL MUST NOT OPERATE.
ƒ Separate the safety/push lever from the wood.
ƒ Next, point the tool in a safe position, pull the trigger and
ƒ THE TOOL MUST NOT OPERATE.
ƒ Without touching the trigger, depress the safety/push
ƒ Pull the trigger.
ƒ THE TOOL MUST OPERATE IF SET IN SEQUENTIAL
ƒ Hold the trigger back while separating the safety/push
ƒ Remove finger from the trigger.
ƒ TOOL OPERATION WILL END.
ƒ (the driver blade will return to the top).
ƒ With the tool off the work piece, pull the trigger.
ƒ Depress the safety/push lever against the work piece.
ƒ THE TOOL MUST OPERATE IF SET IN BUMP FIRE
OPERATING THE TOOL

METHODS OF OPERATION

Sequential Fire Action
1. The operator must first place the tip of the nail into
the metal connector's preformed hole, then hold the
safety nose FULLY against the work surface.
2. Pull the trigger firing a fastener into the material.
3. The tool will not fire again until the trigger is released
and the safety is removed completely from the
material being used.
4. To fire the next fastener, repeat the above steps.
ƒ Caution: do not carry tool with trigger
depressed. This could result in accidental
firing of the tool.

TESTING THE TOOL

MOVE SMOOTHLY.
push lever against the wood.
then hold that position for 5 seconds or longer.
lever against the work piece.
FIRE MODE.
lever from the wood.
MODE.
Interchange Brands Nailers: Operator's Manual