Idiomas disponibles
Idiomas disponibles
If you press the Booster button for more than 8 seconds, the function will automatically go into safety mode. The
"Padlock" icon on the remote control screen indicates this safety setting. The function remains blocked for a
minimum of 8 seconds.
Booster button setting procedure
1.
Activate the remote control.
2.
Select the collar for which you want to set the Booster using the 1/2 or 1/2/3/4 buttons of the remote
control.
3.
Press the key corresponding to the number of the selected collar for approximately 5 seconds until
the Booster stimulation level flashes on the LCD screen.
Press the or — button to modify the Booster stimulation level.
4.
5.
Press the Booster button to confirm the selected level.
If you have several collars, renew the same procedure for each one. The stimulation level selected thanks to the
Booster button can be different for each receiver collar.
5.
Stimulation functions locking | Stimulations inhibited
With this function, you can make it impossible to trigger stimulations on one or more collars.
If you have several collars, the setting can be different for each collar.
Example: stimulations blocked on collar 1 | stimulations not blocked on collar 2
Locking/Unlocking procedure
‒
Select the collar for which you want to lock/unlock the stimulation functions using the 1/2 or 1/2/3/4
buttons of the remote control.
Make a long press simultaneously on the and — buttons on the remote control.
‒
‒
On the remote control screen, the "Padlock" icon appears (lock) or disappear (unlock) for the
stimulation function and Booster function.
6.
Checking battery level
‒
Remote control
To check the battery condition, activate the remote control and look at the battery level indicator on the LCD
screen.
Performance (radio range for instance) may deteriorate as battery becomes weak. Be prepared to charge the
battery following the procedure indicated in § Charging the remote control and/or the collar.
‒
Receiver collar
To check the battery condition, observe the indicator light located on the front of the receiver collar:
‒
Battery sufficiently charged: flashes slowly green
‒
Weak battery: flashes quickly red
When the battery is too weak, the product switches to safety mode and the system locks up. Charge the battery
following the procedure indicated in § Charging the remote control and/or the collar.
7.
Changing the contact points
Two different series of contact points are supplied. The length of the contact points must be sufficient to have
proper contact with the dog's skin, enabling the device to operate correctly.
If you have a long-haired dog and the short contact points fitted to the collar in the factory are inadequate,
remove and replace them with the long ones supplied with the kit.
Carefully tighten them manually (do not use a key).
8.
Fitting the strap
The strap must be adjusted so that the contact points are in contact with the skin of the dog.
Guide d'utilisation CANICOM R-500, R-800, R-1500 – Indice A – Février 2024 - 18/64
