Idiomas disponibles
Idiomas disponibles
Check t hecondition ofguide bareach
time chain issharpened. Aworn guide
barwilldamage thechain andmake
cutting d ifficult.
After e ach use, e nsure O N/STOP
switch isintheSTOP p osition, then
clean allsawdust from theguide bar
andsprocket hole.
Tomaintain guide bar:
• Move ON/STOP
switch toSTOP.
• Loosen a ndremove c hain brake
nuts
and chain brake. Remove bar
and chain from saw.
• Clean the oil holes and bar groove
after each 5 hours of operation.
Remove Sawdust From
_fr_
Guide Bar Groo__.
_
_il
Holes
._
• Burring of guide bar rails is a normal
process of rail wear. Remove these
burrs with a flat file.
• When rail top is uneven, use a fiat
file to restore square edges and
sides.
_h_
File Rail Edges'_
N r_
and Sides
I U I
Square
I
I
Worn Groove
Correct Groove
Replace guide bar when the groove is
worn, the guide bar is bent or cracked.
or when excess heating or burring of
the rails occurs, if replacement
is nec-
essary, use only the guide bar speci-
fied for your saw in the repair parts list
or on the decal located on the chain
saw.
CHECK FUEL MIXTURE LEVEL
• See FUELING ENGINE under the OP-
ERATION section.
LUBRICATION
Bar Oil
"_
1
Fill Cap_
I
• See GUIDE BAR AND CHAIN OIL un-
der the OPERATION section.
INSPECT AND CLEAN UNIT AND
DECALS
• After each use, inspect complete unit
for loose or damaged parts. Clean
the unit and decals using a damp
cloth with a mild detergent,
• Wipe off unit with a clean dry cloth.
CHECK CHAIN BRAKE
• See CHAIN BRAKE in the OPERATION
section.
CLEAN AIR FILTER
A dirty air filter decreases the life and
performance of the engine and in-
creases fuel consumption
and harmful
emissions. Always clean your air filter
after 15 tanks of fuel or 5 hours of op-
eration, whichever comes first. Clean
more frequently in dusty conditions. A
used air filter can never be completely
cleaned, it is advisable to replace your
air filter with a new one after every 50
hours of operation,
or annually, which-
ever comes first. To clean filter:
1. Loosen 3 screws on cylinder
cover
2. Remove cylinder cover.
3. Remove air filter.
4. Clean the air filter using hot soapy
water. Rinse with clean cool water
Air dry completely before reinstalling.
5. Lightly oil air filter before installing to
improve the efficiency of air filter.
Use 2-cycle engine oil or motor oil
(SAE 30). Squeeze excess oil from
filter.
6. Reinstall air filter.
7. Reinstall cylinder cover and 3
screws. Tighten securely.
4inder Cover
Air Filter
Cylinder
Cover
INSPECT MU FFLER AND SPARK AR*
RESTING SCREEN
AS the unit is used, carbon deposits
build up on the muffler and spark ar-
resting screen, and must be removed
to avoid creating a fire hazard or af-
fecting engine performance.
Replace the spark arresting screen if
breaks occur.
15
