Idiomas disponibles
Idiomas disponibles
Operating Instructions and LED Indicator information.
To
Power on
Power off
Pairing
Adjust the volume
Play/pause
Next track
Previous track
Answer a call
End a call
Reject a call
Incoming call
Charging
Charging completed
Pairing
1. Ensure that your phone or Bluetooth device is switched on.
2. To pair the headset that has not been previously paired with a device, please switch on the headset. Then, the
headset enters the pairing mode, and the blue & red indicator light starts to flash alternately quickly. To pair the
headset that has been previously paired with another device, please make sure that the other device is switched off.
3. Activate the Bluetooth on your phone or Bluetooth device, and set it to searching Bluetooth device.
4. Select "Lenco HPB-830" from the list of found devices on your phone or Bluetooth devices.
5. When Bluetooth is paired successfully, there will be prompt tone and the blue light turns to lighting continuously.
Remark: You can switch off the blue Bluetooth light when listening to the music, by pressing the Next (4) and
Previous (2) buttons simultaneously, until the blue led blinks 3 times.
(Repeat this procedure to enable the blue light again.)
The headset that has been previously paired with a device will automatically connect with the device if the device is
powered on and within connecting range. If not, the headset will enter standby mode and the blue light will keep
lighting. Under Bluetooth searching mode or re-connecting mode, the headset will switch off the Bluetooth
automatically after 5 minutes.
Charging
The headset contains a type-C USB cable that can be connected to your computer or other device made for USB
charging. Please plug the type-C USB end of the included USB cable into the USB C socket under the Right ear-cap of
the headphone, and plug the other end into a USB port on your computer or other devices made for USB charging.
Do this
Press and hold MFB for 2~3 seconds; Prompt tone: Power on; LED: Blue light.
Press and hold MFB for 5~6 seconds; Prompt tone: Power off; LED: Red light turn
off.
Press and hold MFB for 5~6 seconds; Prompt tone: Pairing; LED: Blue LED & Red
LED flash alternatively. (NOTE: when ANC is active then the color will be green/blue)
Once the headphone is connected with a device, there will be a prompt tone:
Connected.
Short press +/- button. When the max volume is reached the headphones will
indicate with a prompt tone: Max Volume.
Press MFB once to pause. Press again to resume.
Long press + button
Long press – button
Quick Press MFB
Quick Press MFB
Press and hold MFB for 2 seconds prompt tone: Dong.
Blue LED
Red LED light solid during charging
LED light will turn off
7
