Beeper FX2000-10 Manual De Instrucciones página 22

LEARNING
PRESENTATION OF ORDERS
Report
selected
Level of
battery
FIRST STEPS
1. Turn the ignition key to turn on the scooter.
2. Place one foot on the platform, then twist the throttle grip.
3. The scooter goes straight forward, put the second foot on the platform.
4. To change gear, use the "123*" selector located at the right handlebar.
5. Twist the throttle grip to move forward.
6. Apply the brakes to slow down.
7. Once your scooter has stopped, you can get off and turn it off.
DISPLAY SETTINGS
1. Error codes
Your scooter can, in the event of an electronic problem, show you error codes on the display.
We tell you below what each error code refers to for your information.
Warning: If you disassemble your scooter on your own, it can no longer be taken under warranty.
• E04 - Electrical short circuit
• E10 - Communication failure, the motherboard cannot receive information from the display
• E11 - Motor power supply fault
• E14 - Accelerator failure
• E15 - Electrical failure of the brake system
• E16 - Engine failure
• E21 - Battery BMS fault
• E50 - Electrical overvoltage
• E55 - Calculator temperature too high
• E56 - Insufficient / low battery voltage
23
Status of
LED lights
Speed
Error codes
Mileage
total
*Speed selector
Speed 1: up to 10km/h
Speed 2: up to 15km/h
Speed 3: up to 25km/h