Idiomas disponibles
Idiomas disponibles
• Apply a small amount of toothpaste to the wet bristles.
• Insert the toothbrush into the mouth and position it at a suitable angle (Fig. 4) and switch on.
• Brush the teeth in a circular motion, gently moving the brush head over each section of the
teeth (Fig. 3) for 10 seconds, including the front, back and gum surfaces.
• Do not press the device too hard against the teeth and gums.
• The cleaning cycle lasts 2 min. The toothbrush will generate a pulse every 30s.
• When the set time has elapsed, the device will switch off automatically.
• The device operation can be interrupted at any time using the switch (3).
• Rinse your mouth after brushing is complete. A specialised mouthwash can be used.
• Remove the brush head (7), wash it thoroughly and set aside to dry.
• Wipe off the appliance and place it in a dry place.
TEETH CLEANING – RECOMMENDATIONS
• Divide the teeth into 4 areas – Fig. 3.
• Brush each part for approximately 30 seconds
• The toothbrush signals when the time is up.
• Apply the head bristles to the teeth correctly – Fig. 4
CLEANING AND MAINTENANCE
Clean the appliance after each use.
• Before cleaning, make sure the device is turned off.
• Do not immerse the cable (8) in water.
• Do not use strong or surface-damaging cleaning agents or products.
• Wipe the cord (8) and housing (2) with a damp cloth.
• Rinse the tip (7) thoroughly. Do not squeeze or pull the bristles to avoid damage.
PROBLEMS AND SOLUTIONS
Problem
The head vibrations are
too weak
The head vibrations are
too weak
Operating time is short
The toothbrush does
not work
10
Possible cause
The bristles are too tightly pressed against
the teeth
The toothbrush is not sufficiently charged:
1. The cord is incorrectly connected to the
toothbrush or to the power adapter.
2. Low battery charge.
1. The toothbrush is not charged.
2. The toothbrush has been damaged.
Solution
Press the toothbrush gently against
the teeth
1. Check cord connection.
2. Extend the charging time of the
battery.
1. Charge the toothbrush.
2. Contact the manufacturer's
maintenance service.
