Idiomas disponibles
Idiomas disponibles
5. Fan Assembly. (cont.)
With the hanging bracket secured to the outlet box and
able to support the fan, you are now ready to hang your
fan. Grab the fan firmly with two hands. Slide downrod
through opening in hanging bracket and let hanging ball
rest on the hanging bracket. Turn the hanging ball slot
until it lines up with the hanging bracket tab.
WARNING: Failure to align slot in hanging ball with tab in
hanging bracket may result in serious injury or death.
Tip: Seek the help of another person to hold the
stepladder in place and to help lift the fan up to you once
you are set on the ladder.
Find a secure attachment point (wood ceiling joist highly
recommended) and secure safety cable. It will be
necessary to use a heavy duty wood screw, washer and
lock washer (not supplied) with the safety cable loop.
If necessary, adjust the loop at the end of the safety
cable. The loop at the end of the safety cable should
just fit over the threads on the wood screw. Test safety
cable by pulling on loose end of cable with pliers. If the
safety cable slips, the loop must be adjusted tighter. Extra
cable slack can be left in ceiling area.
6. Wiring.
WARNING: Turn off circuit breakers to current fixture
from breaker panel and be sure switch is turned to the
OFF position.
CAUTION: Be sure outlet box is properly grounded
and that a ground wire (GREEN or Bare) is present.
Make sure all electrical connections comply with Local
Codes or Ordinances and the National Electrical Code.
If you are unfamiliar with electrical wiring or if the
house/building wires are different colors than those
referred to in the diagram to the right, please use a
qualified electrician.
Note: Excess lead wire length from the fan can be
cut to the desired length and then stripped.
When downrod is secured in place on the hanging
bracket, wire the RECEIVER with wire connectors
provided as shown in diagram at right.
Tip: While you are wiring, keep in mind that wires
must not obstruct receiver from sliding into hanging
bracket.
*Wrap each wire connector separately with electrical
tape as an extra safety measure.
Gently insert receiver (flat side up) into hanging
bracket and carefully push wires and taped wire
connectors into outlet box. Let antenna rest outside
of hanging bracket.
wood ceiling
joist
ground (green
or bare)
blue
white
red
yellow
gray
from fan
from
receiver
gray
yellow
red
white
blue
(wiring for receiver)
page 7
safety cable
loop
safety cable
hanging bracket tab
hanging ball slot
motor housing
white supply wire
black supply wire
ground (green)
from
ceiling
from
receiver
antenna
white
AC IN N
black AC IN L
ground (green/yellow)
receiver
wood screw
and washer
*
