Installation - Nostalgia Products HomeCraft HCHREF30SS Instrucciones Y Recetas

CONTROL PANEL

INSTALLATION

WALL DRILLING & BRACKET FIXING
Please read the instructions carefully.
1. Unpack the canopy and check that all functions are working. Ensure
that the voltage (V) and the frequency (Hz) indicated on the serial
plate match the voltage and frequency at the installation site.
2. Check that the area behind the installation surface to be
drilled is clear of any electrical cables or pipes, etc.
3. The stainless steel and glass surfaces of the canopy are very easily
damaged during installation if grazed or knocked by tools. Please
take care to protect the surfaces during installation.
4. Protect the cooktop surface below with cardboard, or the like, to prevent
damage occurring whilst the wall canopy is being installed above.
5. The manufacturer shall not be liable for failure to observe all safety regulations
in force for the correct and normal operation of electrical parts.
7
OFF MOTOR SWITCH: Press to stop the operation.
SPEED SWITCH: Press to run on LOW.
SPEED SWITCH: Press to run on MEDIUM.
SPEED SWITCH: Press to run on HIGH.
ON/OFF LIGHTING: Press to turn on the lights, press again to turn them off.