English
WARNING
If the cutting depth lever is loose, injury can
result. Tighten it securely after adjustment.
To adjust cutting depth, loosen the cutting depth lever
and, while holding the base with one hand, move
the main body up and down to obtain the prescribed
cutting depth. After adjusting to the prescribed cutting
depth, tighten the cutting depth lever securely.
2. Adjusting the angle of inclination
WARNING
If the incline lever is loose, injury can result.
Tighten it securely after adjustment.
You can incline saw blade from 0˚ to a maximum angle
of 55˚ in relation to the base.
As shown in Fig. 19 by loosing the incline lever on the
bevel scale, the saw blade may be inclined to an angle
of 45˚ in relation to the base.
If you use inclination angle of over 45˚, as shown in
Fig. 20 move the incline lever to outside, the saw
blade may be inclined to a maximum angle of 55˚ in
relation to the base.
Always ensure that the incline lever is thoroughly
tightened after making the desired adjustment.
Fig. 19
18
Incline lever
0˚ – 45˚
45˚ – 55˚
3. Regulating the guide (Rip fence) (Fig. 21, 22)
........................................Optional Accessory
Install the wing bolt (B) and lock spring on the base.
Insert the guide into the base, move it left and right
and adjust the cutting position. Tighten the wing bolt
(B) and fi x the guide. The guide can be installed either
from the left or the right side of the main body.
Wing Bolt (B)
Lock
Spring
Base
Fig. 21
Wing Bolt (B), Lock Spring
Fig. 22
Fig. 20
Base
Guide
(Rip Fence)