Idiomas disponibles
Idiomas disponibles
INSTALLING THE BRACKETS
Be sure power to the opener is disconnected.Install and align the
brackets so the sensors will face eachother across the garage
door, with the beam no higher than 6" (15 cm) abovethe floor.
They may be installed in one of three ways, as follows.
Garage door track installation(preferred):
• Slip the curved arms over the rounded edge of each door track,
with the curved arms facing the door. Snap into place against
the side of the track. It should lie flush, with the lip hugging the
back edge of the track, as shown in Figure 1.
If your door track will not support the bracket securely, wall
installation is recommended.
Waft installation (Figure2 & 3):
• Placethe bracket against the wall with curved arms facing the
door. Be sure there is enough clearance for the sensor beamto
be unobstructed.
• If additional depth is needed,an extension bracket
(see Accessories) or wood blocks can be used.
• Use bracket mounting holes as a template to locate and drill (2)
3/16" diameter pilot holes on the wall at each side of the door,
no higher than 6" (15 cm) above the floor.
• Attach brackets to wall with lag screws (not provided).
• If using extension brackets or wood blocks, adjust right and left
assemblies to the same distance out from the mounting surface.
Make sure all door hardware obstructions are cleared.
Floor installation (Figure4):
• Usewood blocks or extension brackets (seeAccessories) to
elevate sensor brackets so the lenses will be no higher than
6" (15 cm) abovethe floor.
• Carefully measure and place right and left assemblies at the
same distance out from the wall. Be sure all door hardware
obstructions are cleared.
• Fastento the floor with concrete anchors as shown.
HARDWARESHOWN ACTUALSIZE
Carriage Bolt
Wing Nut
Insulated
1/4"-20xl/2"
1/4"-20
Staples
Figure I
DOORTRACK MOUNT (RIGHT SIDE)
t
Door
,
Track
;zz
-
Figure2
WALL MOUNT (RIGHT SIDE)
Fasten Wood Block to Wall with
(Not Provided)
Indicator
Sensor
Light
_k
Bracket
a
Y
L2g._
(Not Provided)
Lens
Figure3
WALL MOUNT (RIGHT SIDE)
Exteos,ooorac et
(See Accessories)
(Provided with
!I___:'-
_acket)
""
_
Sensor
(Provided with
.-__
Bracket
Extension _
b_..
-- I!
Indicator
Bracket)
,.v
_Lens
Light
Figure4
J
FLOORMOUNT (RIGHT SIDE)
Attach with
Concrete Anchors
(Not Provided)
Indicator
Light
Sensor
Bracket
21
