Programming The Remote Control; General Information - SOMFY io homecontrol VSYSTEMPRO Manual De Uso

When receiving a call: operation of the communication and control buttons (no. 2)
Answering a call:
1. Press this button to accept the communication, the LED located behind the pictogram
and the communication is activated (audio mode only for communication between monitors).
2. Press this button to terminate the communication, the LED located behind the pictogram
and the communication is terminated.
Activating the external module relay:
When communication with the external module is active, pressing this button activates its relay; see the
guide at the beginning of this document to see the function associated with this relay.
If the relay module ref. 9020031 is installed, pressing this button activates relay no. 1 (R1); see the guide at
the beginning of this document to see the function associated with this relay.
Rejecting a call:
Press once to reject the communication. The visitor will not be informed of the rejection.
During a communication: operation of the communication and control buttons (no. 2)
End of the current communication:
3. Press this button to terminate the communication, the LED located behind the pictogram
and the communication is terminated.
Activating the external module relay:
When communication with the external module is active, pressing this button activates its relay; see the
guide at the beginning of this document to see the function associated with this relay.
If the relay module ref. 9020031 is installed, pressing this button activates relay no. 1 (R1); see the guide at
the beginning of this document to see the function associated with this relay.
If the relay modules ref. 9020031 are installed, press the number of times corresponding to the relay to be
activated (R1 to R8).
Note: see the guide at the beginning of this document to see the functions associated with these relays.

3.1 General information

The io-homecontrol® remote control corresponding to the monitor can be used to control up to five Somfy products or groups
of products equipped with an io-homecontrol® receiver.
To programme the control, you must remove the monitor from its rear section.
To disassemble the monitor:
[1]. Remove the monitor from its rear section.
- Unclip the le -hand side of the front panel of the monitor.
- Turn the front panel then slide it to the le .
Copyright © 2016 Somfy SAS. All rights reserved.

3 PROGRAMMING THE REMOTE CONTROL

EN
lights up
goes out
goes out
5