Beurer IH50 Manual De Instrucciones página 19

Problem/ Possible Cause/Remedy
Question
Output is too 1. The batteries are flat. Replace the
low. batteries or connect the power
supply unit and try again.
2. There are air bubbles inside the
medicine container which are pre-
venting the medicine from coming
into continuous contact with the
mesh. Please check and remove
any air bubbles.
3. Particles on the mesh are imped-
ing output. To remove the par-
ticles, fill the nebuliser with 2 to
3 drops of vinegar and 3 to 6 ml
of water, then nebulise this solu-
tion completely. Do not inhale this
spray and ensure that you clean
and disinfect the medicine con-
tainer afterwards (see page 17).
If the output does not improve, re-
place the mesh.
4. The mesh is worn out.
Which medi- Only the doctor can advise you
cines are suit- which medicine to use to treat your
able for inhala- condition. Consult your doctor.
tion? With the IH 50, you can atomise
medicines with a viscosity lower
than 3.
Some inhala- This is normal and occurs for techni-
tion solution cal reasons. Stop inhaling as soon
remains in the as you can hear a marked differ-
nebuliser. ence in the sound made by the at-
omiser, or when the device switches
off automatically due to insufficient
inhalant.
What special 1. In babies, the mask should cover
steps should the mouth and nose to guarantee
be taken for effective inhalation.
babies and 2. In children, the mask should also
children? cover the mouth and nose. Nebu-
lisation next to a sleeping person
is not suitable because insufficient
medicine reaches the lungs.
Note: Children should only use the
device with help and under supervi-
sion of an adult. Never leave a child
alone with the nebuliser.
Inhalation with This is for technical reasons. Less
the mask takes medicine is inhaled per breath
longer. through the mask holes than us-
ing the mouthpiece. The aerosol is
mixed with ambient air through the
holes in the mask.
Does each user This is absolutely necessary for hy-
need their own giene reasons.
accessories?
All manuals and user guides at all-guides.com
9. Technical specifications
Dimensions
(LxWxH)
Weight
Battery operation
Volume
Medicine flow
Oscillation
frequency
Housing material ABS / TPE
Mains
connection
Operating
conditions
Storage and
transport
conditions
Subject to technical modifications.
Wearing parts are not covered by the guarantee.
Spare parts
Designation
Mouthpiece
Adult mask
Child mask
Mesh atomiser with
medicine container
Power pack
Connecting piece
Yearpack
(Mouthpiece, Adult mask,
Child mask, Mesh atomiser,
Connecting piece)
All measurements were obtained with a sodium chlo-
ride solution using a laser diffraction method.
19
72 x 59 x 143 mm
238 g incl. batteries
4 x 1.5 V type AA, Mignon (LR6)
max. 8 ml
approx. 0.25 ml/min.
100 kHz
100 – 240 V ~, 50 – 60 Hz; 0,15 A
Temperature: +5 °C – +40 °C
Relative humidity: <80 % non-con-
densing
Temperature: -10 °C – +45 °C
Relative humidity: <80 % non-con-
densing
Material
PP
PVC
PVC
PC
PC+ABS
PC
PP,
PVC, EVA,
PET
REF
162.658
162.712
162.659
162.711
071.18
162.665
603.05