Mains Connection - LK H775BM Instrucciones De Montaje

Refit the screws (64), and the washers (65), Fig.5,
and tighten securely.
Lower the bottom trim section (56) for the main post
(55) down over the boss section of the main body (1).
5. FITTING THE HANDLEBAR.-
Bring the handlebar (57) up to the handlebar stem
(55).
Refit the screws (62), Fig.6, and tighten securely, then
fit the bracket cover (59) and screw with screw (61).
6. BOTTLE HOLDER ASSEMBLY.-
Place the bottle holder (60) with the support (63) in
the tube (55), and screw with screws (110) Fig.6.
7. FITTING THE MONITOR.-
Place the monitor (58) on top of the plate on the main
post (55), as shown in Fig.6, making sure not to pinch
the wires.
Use supplied screws (29) to hold the monitor in place,
Fig.6.
Next, connect terminals, sticking out of the handlebar
post (55), and terminals, sticking out of the monitor
(58), Fig.6.
Take the (37) covers and position them on the main
post (55), Fig.6A. Now use the screws (38) to attach
them to the post.
Take the (127) covers and position them on the
monitor (58), Fig.6B. Now use the screws (128) to
attach them to the post.
8. FITTING THE SADDLE PROFILE
Firstly (Fig 7), place the saddle profile (77) close to
the main body (1) and connect terminal from saddle
profile. Afterwards introduce tube of main body in
aluminium profile, paying special attention to the
cables.
Insert the head of the screws in the slots of the rail
and tighten the nuts.
Fit the trim (74). Finally, place screw (75) and tighten
securely.
9. ATTACHING THE SADDLE
Place saddle back as shown in Fig 8 and screw with
screws (94) securely.
MOD. H775BM
Take the back cover (95), position them on the tube
(91). Then screw it with the screws (39).
Take the saddle back support tube (91) and insert the
cover (93). Slip the saddle back support tube (91)
over the boss on the body (77), Fig.8A.
Refit the screws (62), and tighten securely.
Lower the bottom trim section (93) down over the
boss section of the body (77).
To adjust the seat position, pull the lever (112).
Position in the rail and release the lever again.
10. LEVELLING.
Once the unit has been placed into its final position,
make sure that it sits flat on the floor and that it is
level. This can be achieved by screwing the
adjustable feet (70) up or down, as shown in (Fig 9).
To level the seat:
Loosen the screws (84) under the rail. Level seating
position with the screws (108). Tighten the screws
(84) again fig.9A.
11. MOVEMENT & STORAGE
The unit is equipped with wheels (67) to make it
easier to move. The wheels located at the front of
your unit make it easier to move it into a chosen
position, by lifting the rear of the unit up slightly and
pushing it, as shown in (Fig 9). Store your unit in a dry
place, preferably
temperature.
12.

MAINS CONNECTION

Insert the jack (g) on the transformer (97) into the
connection hole (h) on the main body (1) (bottom, rear
of the machine) and then plug the transformer into a
230 V mains supply, (Fig 11).
Do not hesitate to get touch with the Technical
Assistance Service if you have any queries by phoning
customer services (see last page in manual)
BH RESERVES THE RIGHT TO MODIFY THE
SPECIFICATIONS OF ITS PRODUCTS WITHOUT
PRIOR NOTICE
9
not subject to changes in