Idiomas disponibles
Idiomas disponibles
Vertical steam ironing
Ideal for removing creases in suits, jackets, skirts, curtains, etc...
•
Hang the garment on a hanger and hold the fabric slightly taut with one hand. The
steam is very hot, so you should always do this with the garment on a hanger
– never iron clothes which someone is wearing.
•
Set the thermostat control to
•
Press the burst of steam button
from top to bottom – fig.11.
Spray Function
•
Whether steam or dry ironing, you are able to use the Spray button
laundry to remove stubborn creases –
Anti-drip function
When using for the first
time, wait until the light
goes out before
obtaining steam.
Maintenance and cleaning
Cleaning the anti-scale valve
Put the switch into the C C o o r r d d l l e e s s s s position
•
base
•
Empty the water compartment and place the steam control on
•
To remove the anti-scale valve, pull it up –
•
Soak the valve in a cup of white spirit vinegar or plain lemon juice for a few hours –
fig.15.
•
Rinse the valve under running water.
•
Replace the anti-scale valve.
The self-cleaning
function helps to slow
down scaling in your
iron.
In order to extend the
life of your iron, use the
Self-Cleaning function
once a month.
Cleaning the soleplate
•
While the soleplate is still slightly warm, clean it by wiping over it with a damp non-
metallic cloth.
MAX
– fig.8.
button repeatedly –
•
Set the temperature for the fabric to be ironed.
•
Set the steam control to
•
You may start ironing when the thermostat light goes out.
fig.12.
Your iron is equipped with an integrated anti-scale system . This system will help to pro-
vide:
•
a better ironing quality with a constant flow of steam,
•
lasting performance from your appliance.
•
If the soleplate temperature is too low, the iron will not produce steam because of the
anti-drip technology which prevents droplets of water leaking from the soleplate.
•
In order to obtain steam again, put your iron back on its base.
fig.13.
•
Put the switch into the C C o o r r d d l l e e s s s s position
base
•
Set the steam control to
•
Place your iron on its heel, set the thermostat button to
indicator light to go out – fig.9.
•
Take the iron from its base and place the iron horizontally over a sink.
•
Remove the anti-scale valve – fig.13.
•
Shake the iron gently, over the sink, until some of the water in the water tank (with
the impurities) has flowed out through the soleplate – fig.15.
•
At the end of the operation, push the anti-scale valve back into position.
fig.4
moving the iron
DRY
–
fig.6.
to dampen
Integrated anti-scale system
(once a month)
–
fig.5
and remove the iron from its
DRY
DRY
–
fig.6
and fill the water tank to MAX.
Hold the iron a few
centimetres from the
fabric to avoid burning
delicate fabrics.
Every fifth time you
press the button,
return the iron to the
horizontal position.
Dry ironing
Make sure that there
is water in the tank
before using this
button.
Be careful !
Unplug your iron and
let it cool down before
.
cleaning it.
- Never touch the end
of the valve.
- The iron will not
function without the
anti-scale valve.
Self-cleaning
–
fig.5
and remove the iron from its
MAX
and wait for the
Never use abrasive or
aggressive products on
the soleplate.
ENG
7
