cecotec CONGA ROCKSTAR AGILE JALISCO Manual De Instrucciones página 42

ENGLISH
- Never immerse the device in water or other liquids, do not allow liquids to enter the device.
- Do not use abrasive cleaners or scouring pads to clean the product.
- Do not leave the device in a place with direct sunlight.
- Do not leave the device in a wet place after cleaning it.
- After the brush has been used for a long time, bristles might start to tangle with hair and
other particles. Clean it in order for it to operate correctly again.
Filters and tank cleaning. Fig. 8
- To avoid the appliance from overheating and losing suction power, it is suggested to clean
the filters frequently. To make the most of the suction power, it is suggested to clean the
filter after every use.
- The filters shelf life will depend on the accumulated use and the type of particles which
are frequently vacuumed. It is recommended to replace the filters approximately every 6
months.
Make sure the vacuum cleaner is switched off and is not connected to a mains socket.
1.
Press the dust-tank release button and remove it.
2.
Remove the filter system from inside the tank and separate the filters for cleaning.
3.
Put the filters back in their original position inside the dust tank.
4.
Refit the dust tank.
5.
- Vacuum and shake the filters to remove every particle and dust remain that may block
them and difficult the correct air circulation. Remember not to use the vacuum cleaner
without the filters properly assembled.
- Filters cannot be washed inside a washing machine nor dried with a hair dryer.
- Do not brush the high-efficiency filter.
Cleaning the Jalisco brush
The main brush rotates at high speed and helps pulling the dirt into the suction mouth. This
brush is in contact with the floor, and therefore with dirt, so it can be worn out over time,
negatively affecting cleaning efficiency. It is recommended to clean the Jalisco brush once a
week (depending on usage frequency).
Make sure the vacuum cleaner is switched off and is not connected to a mains socket.
1.
Slide the tab located on the side of the motorised brush. Fig. 9
2.
You can then remove the Jalisco brush from inside the motorised brush and clean it.
3.
- To avoid damage to the brush, you must remove any hair wrapped around the Jalisco brush.
- You can clean the Jalisco brush with warm water, do not use soap or detergents. However,
it is recommended that you shake it out or vacuum it, to avoid inserting it wet in motorised
brush.
- If you decide to wash the Jalisco brush, make sure it is completely dry before installing it
again on the vacuum cleaner.
- When replacing the Jalisco brush, make sure it is properly installed.
42
CONGA ROCKSTAR AGILE JALISCO