AXIS A1610 Network Door Controller
•
Do not connect the Axis product to a receptacle controlled by a switch.
•
Battery
-
The 3.0 V lithium battery used by the Axis product is a UL recognized
component. (Type: BR2032, diameter: 20 mm (0.78 in), manufacturers:
Power Glory (Omnergy)). The following battery type is also a UL recognized
component: Type CR2032.
-
Users shall not replace the battery. If the battery needs replacing, it must
be done by a trained technician only.
-
Used batteries shall be disposed of according to local laws and regulations,
which may vary from state to state. Waste BR/CR lithium cells are neither
listed nor exempted from the USEPA hazardous waste regulations. Waste
lithium batteries can be considered reactive hazardous waste if there is a
significant amount of unreacted, or unconsumed lithium remaining. For
information about how to dispose of used lithium batteries, contact your local
authority for waste disposal.
Specifications
•
Operating conditions
Normal use (not evaluated by UL)
UL 294
•
Wiring requirements
-
UL listed or R/C AWM wires that have a conductor gauge range of
AWG 22–14 shall be used.
-
The minimum conductor gauge for connection between the power sourcing
equipment (PSE) or power injector and the powered device (PD) is 26 AWG.
-
Minimum PoE category 5e, shielded cable, required for PoE.
-
This product is not intended for outside wiring as covered by Article 800 in the
National Electrical Code, NFPA 70.
•
Connectors
-
Power Connector – For UL security applications, the product shall be powered
by a UL 294 or UL 603 listed Class 2 low-voltage power SELV and limited
power supply with appropriate ratings.
-
External power to relays - If the relays are connected to an external power
source this must be UL 294 listed Class 2 low-voltage power SELV and limited
power supply.
-40 °C to 55 °C (-40 °F to 131 °F)
Humidity 20–85% RH (non-condensing)
0 °C to 55 °C (32 °F to 131 °F), maximum
humidity 85%.
6
