cecotec CONGA ROCKSTAR 2500 ULTIMATE ERGOWET Manual De Instrucciones página 26

ENGLISH
1. PARTS AND COMPONENTS
Fig. 1
Vacuuming brush head release button
1.
Vacuuming tube release button
2.
Dust tank bottom cover unlock button
3.
Tank opening button and filter access
4.
Vacuuming brush head
5.
Power button
6.
Power adapter
7.
Charging base
8.
Jaliscazo brush
9.
2-in-1 narrow accessory for corners and furniture
10.
2-in-1 wide accessory for corners and furniture
11.
Motorised brush for upholstery
12.
Union elbow
13.
Long brush
14.
Extensible tube
15.
Vacuuming flexible tube
16.
Watertank accessory
17.
Special brush for fabrics
18.
Fig. 1.1
Display
1.
Speed button
2.
Power button
3.
Battery
4.
Battery release button
5.
2. BEFORE USE
- Take the product out of the box.
- Check that all components included are present. If there is any piece missing or not in good
condition, immediately contact the Technical Support Service of Cecotec.
- Fully charge the device before the first use.
- During the first 3 uses, it is recommended to charge the device for 12 hours between uses.
Once the battery has been charged and used, it will start charging normally.
- The normal charge time is 3 hours approx. When the battery is fully charged, unplug it.
- Remove the first-use tab installed in the filter.
50
Box contents
- Conga Rockstar 2500 Ultimate ErgoWet vacuum cleaner
- 2-in-1 wide accessory for corners and furniture
- 2-in-1 narrow accessory for corners and furniture
- Jaliscazo brush
- Vacuuming flexible tube
- Motorised brush for upholstery.
- Extensible tube.
- Long brush
- Union elbow
- Special brush for fabrics
- Watertank accessory
- 1 spare high-efficiency filter
- 1 spare mop
- Charging base
- Instruction manual
3. PRODUCT ASSEMBLY
Vacuuming tube and brush head assembly
- To install the vacuuming brush head into the vacuuming tube, align both of them making
sure the tab on the brush head matches the guides on the tube, and introduce one into the
other until they are firmly fixed.
- To disassemble them, press the vacuuming brush head release button and pull from the
vacuuming tube while you hold the vacuuming brush head.
Note
When assembling these 2 parts, make sure the handle and the brush head are facing the same
direction.
Vacuuming tube, vacuuming brush head and main body assembly
Fig. 2.
To complete the installation of the device, hold the vacuuming tube with the brush head
assembled upright and introduce the tube in the main body.
Battery assembly
Fig. 3
Introduce the battery in the slot located in the main body following the guides. Once it is
introduced, it will click into place. Once inserted, check that it is secured in position.
To disassemble the battery, press the release button (Fig. 1.1) and remove the battery.
ENGLISH
CONGA ROCKSTAR 2500 X-TREME ULTIMATE ERGOWET 51