Better Homes and Gardens Autumn Lane BH19-D1-1011-08 Instrucciones De Montaje página 4

B/C
2
2
M7 x 35 mm Self-tapping Screw
(6 used in this step for
Apron Assembly only)
NOTE: DO NOT fully tighten all the screws until the chair has been adjusted and all the legs are levelled so that
they do not wobble. Once adjusted then go back and tighten while making sure that the unit remains level.
1.
Unpack the unit and confirm that you have all the hardware and required parts.
2.
Place one Seat Assembly (A) upside down on a smooth and protected surface.
3.
With the pilot holes on the Seat Board (A) as a guide, align and attach Left and Right Legs (B and C) to the Seat
Board using six 35 mm Self-tapping Screws (1). Make sure the arrow FRONT sticker on the Legs is pointing
towards front of the unit.
4.
Attach two Crossbars (D) between the Left and Right Legs (B and C) using four 42 mm Self-tapping Screws (2).
Tighten the Self-tapping Screws with the provided hex wrench.
5.
Stand the chair upright. Check it is balance and securely tighten all the self-tapping screws.
6.
Repeat the process to assemble the other chair.
Assembly Instructions
D
1
B/C
A
①
DO NOT fully tighten the self-tapping screws in this step.
D
B
M7 x 42 mm Self-tapping Screw
(4 used in this step)
4
C
D
A
②