Replacement Of The Sanding Drum; Application Tips - Lagler PROFIT Traducción De Las Instrucciones De Servicio Originales

English

3.7 REPLACEMENT OF THE SANDING DRUM

Replace the sanding drum when the drum cover is damaged. Open the drum nut using the box wrench.
Caution: Left hand thread!
• It is possible to avoid leaving deep sanding tracks caused by excessively coarse grit size by initially selecting a
fi ne grit size for the fi rst sanding process.
• Carry out a test sanding process using a 50 or 60 grit size (a few test strokes). If this test is satisfactory and you
envisage a good sanding result within a reasonable period, it is more effi cient to start the sanding work off with
these fi ner grit sizes.
• You can avoid creating deep sanding tracks with the mentioned grit sizes by adhering to the grit size sequence
and not skipping more than one grit size at a time.
• After each sanding pass, vacuum the fl oor thoroughly, and clean the machine's wheels before starting each new
sanding operation.
• When changing to a new sanding material, always start work in a less well lit area of the room until the sanding
material loses its initial aggressive sanding behaviour.
• Always sand from left to right. This ensures that the left-hand wheel always runs over the newly sanded surface,
making the surface more even with each sanding pass and preventing waviness.
One sanding pass comprises a forward and reverse movement over the same track without offset. Avoid a sand-
ing track offset of more than 85%.
• For other informative and important application tips, please refer to the LÄGLER
chure „Sanding wooden fl oors"!
28
4

APPLICATION TIPS

4
Application tips
®
application technology bro-
PROFIT
01.01.2013