GreenWorks GD60BPB Manual Del Operario página 7

EN
Remove the battery from the machine before
maintenance.
5.1 CLEAN THE MACHINE
The machine must be dry. Humidity can cause risks of
electrical shocks.
• Clear the unwanted material out of the air vent with
a vacuum cleaner.
• Do not spray the air vent or put the air vent in
solvents.
• Clean the housing and the plastic components with
a moist and soft cloth.
• Banned washing
6 TRANSPORTATION AND
STORAGE
Remove the battery pack from the machine before
transportation and storage.
6.1 MOVE THE MACHINE
• Only hold the machine with the handgrip.
6.2 STORE THE MACHINE
• Clean the machine before storage.
• Make sure that the motor is not hot when you store
the machine.
• Make sure that the machine does not have loose
or damaged parts. If it is necessary, do these steps/
instructions:
• Replace the damaged parts.
• Tighten the bolts.
• Speak to a person of an approved service
center.
• Store the machine in a dry area.
• Make sure that children cannot come near the
machine.
7 TROUBLESHOOTING
PROBLEM
The motor does
not start when
you pull the trig-
ger.
WARNING
WARNING
WARNING
POSSIBLE SOLUTION
CAUSE
Make sure that
The battery pack
you tightly install
is not installed
the battery pack
tightly.
in the machine.
The battery pack Charge the bat-
is out of power. tery pack.
English
PROBLEM
The machine
does not start.
The air does not
flow through the
tube when you
start the ma-
chine.
8 TECHNICAL DATA
Voltage
Air volume
Air speed
Weight (without battery pack)
Measured sound pressure level L
Guaranteed sound power level
Vibration
Battery model
Charger model
9 WARRANTY
(The full warranty terms and conditions can be found on
Greenworks website )
The Greenworks warranty is 3 years on the product,
and 2 years on batteries (consumer/private usage)
from the date of purchase. This warranty covers
manufacturing faults. A faulty product under warranty
might be either repaired or replaced. A unit that has
been misused or used in other ways then described
in the owner's manual might be rejected for warranty.
Normal wear, and wear parts are not considered as
warranty. The original manufacturer warranty is not
affected by any additional warranty offered by a dealer
or retailer.
6
POSSIBLE SOLUTION
CAUSE
The power switch
is defective.
Replace the de-
The motor is de- fective parts by
fective. an approved
service center.
The PCB board is
defective.
The air inlet or
Remove the
tube outlet has a
blockage.
blockage.
60 V DC
15.6 m³/min
257 km/h
4.3 kg
= 83.9 dB(A),
PA
K = 3 dB(A)
PA
L = 98 dB(A)
WA.d
2
< 2.5 m/s
2
m/s
G60B2, G60B5,
G60B4 and other
BAC series
G60UC, G60x2UC6
and other CAC ser-
ies
Double-insulated
construction
, K = 1.5