Samsung WMN4277TT Guia De Instalacion página 2

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 41
Wall Bracket Assembly
[ Check the type of the wall before installing.
Standard Installation Requirements by Wall Type
• Can only be mounted on a concrete or interior wall of sufficient thickness. Refer to the diagrams below.
Min. 50 mm
MDF
PW, etc.
With reinforcement
Min.
50 mm
Min. 10 mm
MDF, PW
NOTE
MDF = Medium Density Fiberboard
PW = Plywood
• Cannot be mounted on unreinforced wall or drywall surfaces.
MDF, PW,
Concrete
0~24 mm
1
Install the angle adjustment bracket on the wall as shown in
the figure.
2
4
1
6
Tighten the angle adjustment bracket by using anchors and
screwsⓐ orderly from ① to ⑦.
If it cannot be installed on the assigned area, install at the
nearest place.
Check the solidity of the wall before the installation. Strengthen the wall and install the bracket if the wall is not firm enough.
The supplied screws and anchors are for installing on concrete walls.
For the wall of plaster, marble, or steel, use the appropriate screws.
Min. 30 mm
MDF, PW
Art Wall
Min. 10 mm
MDF, PW
Min. 30 mm
Concrete
Art Wall
Min. 10 mm
MDF, PW
Art Wall
Without
reinforcement
Cannot install on drywall
3
5
Screwⓐ 5EA
Screwⓐ 2EA
7
Min.
25 mm
MDF, PW
(Exc. drywall
thickness)
Min.
25 mm
Mixed Concrete
Wall (Exc. drywall
thickness)
Drywall
How to Tighten Anchors or Screwsⓐ
Make a hole in the wall with the drill of
6X50.
Clean up the hole.
Insert the supplied anchor to the hole.
Match the angle adjustment bracket to the
holes on the wall and tighten the screwsⓐ.
 Use the drill with the required size when making a hole in
the wall. Be sure to follow the directions for the installation
to avoid safety problems.
loading