Better Homes and Gardens Bankston BH17-084-097-30 Instrucciones De Montaje página 4

2
3
4
A
M6 x 80 mm Bolt
(4 used in this step)
ready to assemble. To avoid causing damages to the thread, DO NOT over-tighten the nuts or bolts.
1. Unpack the unit and confirm that you have all the hardware and required parts.
2. Lay one Chair Backrest (A) on a smooth and protective surface with the threaded holes facing up.
3. Attach one Seat Frame (C) to the Chair Backrest (A) so that the drilled holes on the back rail overlap the
threaded inserts on the middle rail of the backrest. Insert three M6 x 35 mm Bolts (1) with the Small
Lock Washers (3) and Small Flat Washers (4) through the back rail of the Seat Frame (C) and screw into
the threaded inserts on the Backrest (A).
4. Fasten the Seat Frame (C) to the Chair Backrest (A) by inserting four M6 x 80 mm Bolts (2) with the
Small Washers (3 and 4) through the drilled holes on the Seat Frame at rear corner blocks and loosely
tighten into the threaded inserts on the Backrest.
Assembly Instructions
1
3
4
C
②
DO NOT fully tighten the bolts or nuts initially until all the bolts or nuts are
DO NOT
C
A
Small Lock Washer
(7 used in this step)
③
fully tighten the bolts.
4
M6 x 35 mm Bolt
(3 used in this step)
①
Small Flat Washer
(7 used in this step)
④