Royal Catering RCWK-8L-AUT Manual De Instrucciones página 20

Set the turn off time to 22:30
3. Press "SET" to select the "
4. Press "SET" to select the "
5. Press "SET" to select the "OFF" code or wait 20 seconds until the display shows "OFF."
6. Press "ON/OFF" to turn on the device, press and hold the "RESERVATION" button until the
"RESERVATION" indicator light comes on. Setting is complete.
3.4. Troubleshooting
Error code
The display is not
working
," then use the "UP/DOWN" buttons to set the hour to "22."
," then use the "UP/DOWN" buttons to set the minutes to "30."
Cause of the error
No water in the tank, water flows
slowly, water pressure low.
Open circuit or short circuit of the
temperature sensor.
The water in the tank cannot reach a
low level after filling with water for
20 minutes.
The water cannot reach the set
temperature after heating for 35
minutes
Malfunction on the motherboard or
protection of the thermostat against
overheating.
EN
When the unit is turned on, there is no
water in the tank. The ELL code appears
during the water filling process. Please
open the water outlet tap and check if the
water inlet pressure is sufficient.
Please check if the sensor cable is
disconnected or if the motherboard is
working properly.
The water pressure is low or the inlet valve
is blocked by debris.
1) Check that the water pressure is
adequate.
2) Clean the limestone regularly.
3) Check that the inlet switch is turned on.
4) Check if there is no water in the area.
1) Check whether the appliance can heat
the water normally after switching on.
Possible solution