Idiomas disponibles
Idiomas disponibles
IRC-Connect
Stockholm, 1 November 2022
Lars Eklöf, Managing Director
Signature of issuer
Authorised Representative UK
James McAllister, General Manager
Atlas Copco Ltd
Swallowdale Lane
Hemel Hempstead
Hertfordshire HP2 7EA
Regional Requirements
WARNING
This product can expose you to chemicals including lead,
which is known to the State of California to cause cancer
and birth defects or other reproductive harm. For more
information go to
https://www.p65warnings.ca.gov/
Safety
DO NOT DISCARD - GIVE TO USER
WARNING Read all safety warnings, instructions, il-
lustrations and specifications provided with this
power tool.
Failure to follow all instructions listed below may result
in electric shock, fire, and/or serious injury.
Save all warnings and instructions for future refer-
ence.
WARNING All locally legislated safety rules regard-
ing installation, operation and maintenance shall be
respected at all times.
Statement of Use
• For professional use only.
• This product and its accessories must not be modified in
any way.
• Do not use this product if it has been damaged.
• If the product data or hazard warning signs on the product
cease to be legible or become detached, replace without
delay.
• The product must only be installed, operated and serviced
by qualified personnel in an industrial environment.
© Atlas Copco Industrial Technique AB - 9836 6341 00
Intended use
The IRC-Connect is designed to enable the wireless commu-
nication between a remote device and a torque or torque/angle
transducer.
This tool is intended to be used with the following products.
No other use permitted.
Devices
• STa 6000
• STa 6000 Plus
• STpad
• STpalm
Transducers
• IRTT-B
• QRTT-B
• SRTT-B
Label
The tool designation can be checked on the identification la-
bel shown in the figure below:
Product Specific Instructions
Electrostatic discharges
The product components are electrostatic sen-
sitive devices; DO NOT touch any electrical
contact to avoid risk of module damages. To
avoid electrostatic discharges, touch a metal-
lic object before handling any module.
Service and Maintenance
Maintenance recommendations
The tool should be calibrated regularly once a year.
Replace the battery in case of any sign of malfunctioning and/
or overheat.
NOTICE: Use only batteries supplied by Atlas Copco.
Preventing ESD Problems
The components inside the product and controller are sensi-
tive to electrostatic discharge. To avoid future malfunction,
make sure that service and maintenance is carried out in an
ESD approved work environment. The figure below shows an
example of an appropriate service work station.
Safety Information
5
