Makita DFS250 Manual De Instrucciones página 8

ASSEMBLY
CAUTION:
Always be sure that the tool is
switched off and the battery cartridge is removed
before carrying out any work on the tool.
Installing or removing driver bit/socket bit
For DFS250
1
Fig.11
► 1. Locator
2
Fig.12
► 1. Locator 2. Driver bit 3. Magnetic bit holder
To remove the driver bit, pull the locator, and then grasp the
bit with a pair of pliers and pull the bit out of the magnetic bit
holder. To install the driver bit, push it firmly into the magnetic
bit holder. Then install the locator by pushing it firmly back.
For DFS251
1
Fig.13
► 1. Locator
Fig.14
► 1. Locator 2. Socket bit
To remove the socket bit, pull the locator, and then pull
the socket bit. To install the socket bit, push it firmly into
the sleeve. Then install the locator by pushing it firmly
back.
1
3
Fig.15
► 1. Groove 2. Hook 3. Screw
The hook is convenient for temporarily hanging the tool.
This can be installed on either side of the tool. To install
the hook, insert it into a groove in the tool housing on
either side and then secure it with a screw. To remove,
loosen the screw and then take it out.
8 ENGLISH
Installing hook
WARNING:
Use the hanging/mounting parts
for their intended purposes only, e.g., hanging the
tool on a tool belt between jobs or work intervals.
WARNING:
Be careful not to overload the
hook as too much force or irregular overburden
may cause damages to the tool resulting in per-
sonal injury.
CAUTION:
When installing the hook, always
secure it with the screw firmly. If not, the hook
may come off from the tool and result in the personal
injury.
CAUTION:
Make sure to hang the tool
securely before releasing your hold. Insufficient
or unbalanced hooking may cause falling off and you
may be injured.
1
2
3
1
2
1
2
3