Makita DFS250 Manual De Instrucciones página 7

In push drive mode with the switch trigger locked, the lamp
goes out approximately one minute after the motor stops.
NOTE: While pulling the switch trigger, the lamp
status cannot be changed.
NOTE: For approximately 10 seconds after releasing
the switch trigger, the lamp status can be changed.
NOTE: Use a dry cloth to wipe the dirt off the lens of
the lamp. Be careful not to scratch the lens of lamp, or
it may lower the illumination.
Reversing switch action
1
Fig.6
► 1. Reversing switch lever
CAUTION:
Always check the direction of
rotation before operation.
CAUTION:
Use the reversing switch only after
the tool comes to a complete stop. Changing the direc-
tion of rotation before the tool stops may damage the tool.
CAUTION:
When not operating the tool, always
set the reversing switch lever to the neutral position.
This tool has a reversing switch to change the direc-
tion of rotation. Move the reversing switch lever to the
position (A side) for clockwise rotation or to the posi-
tion (B side) for counterclockwise rotation.
When the reversing switch lever is in the neutral posi-
tion, the switch trigger cannot be pulled.
Depth adjustment
1
Fig.7
► 1. Locator
The depth can be adjusted by turning the locator. Turn it in "B"
direction for less depth and in "A" direction for more depth. One
full turn of the locator equals 2 mm (1/16") change in depth.
B B
A
A
A
B
For DFS250
Fig.8
► 1. Locator
For DFS251
Fig.9
► 1. Locator
Adjust the locator so that the distance between the tip
of the locator and the screw head is approximately 3
mm (1/8") as shown in the figures. Drive a trial screw
into your material or a piece of duplicate material. If the
depth is still not suitable for the screw, continue adjust-
ing until you obtain the proper depth setting.
Hook
CAUTION:
hanging the tool with the hook.
CAUTION:
tion or on potentially unstable surface.
B
Fig.10
► 1. Hook
The hook is convenient for temporarily hanging the tool.
7 ENGLISH
3 mm (1/8")
3 mm (1/8")
Always remove the battery when
Never hook the tool at high loca-
1
1
1