Idiomas disponibles
Idiomas disponibles
Make sure that the water tank is set properly.
When you empty water from a water tank
Handle
18
Your dehumidifier will not be operated
when the water tank is full of water or it is
not set properly.
How to remove
Draw the water tank gently toward you by
holding the concave part of the tank.
How to set
Push the tank horizontally and gently. The
handle lies down by itself.
1. Remove water tank from the
dehumidifer.
2. Hold the tank by the handle and carry it
gently.
3.Tilt the tank to the direction as shown.
and slowly empty the water out of the
tank.
4. Set the tank in the dehumidifer.
Note:
After the dehumidifying operation, water is
collected in the water tank. When the tank
is full of water, the dehumidifier stops
operating automatically and the buzzer
sounds. The buzzer sounds for 20
seconds when the tank is taken out during
the operation.
How to Operate
•
Your dehumidifier will stop automatically after the hours set by
the timer (0H to 24H)
•
In any mode, you can press "TIMER" switch to set the timer 0H
to 24H
Plug in the dehumidifier to an outlet.
•
If the water is full of water indicator light,
the rest are not displayed .
•
Make sure that the water tank is set
properly.
Press "
" switch.
•
"Dehumidification" mode lamp will light up
Set the unit to the desired operation by pressing
"Mode" switch.
•
Every timer you press the "Mode" switch, the mode select lamps
light up in turn as:
For timer Operation
Press "Timer" switch to set the timer.
•
TIMER (timer function) press timer to program time and "Timer"
light "Hr" comes on while timer is programmed. Before
programming, make sure that the timer function has not been
activated (the light must be off). The following timer programs
are available.
19
