Idiomas disponibles
Idiomas disponibles
Unpacking Your Refrigerator
1.
Remove all packaging material. This includes the foam base and all adhesive
tape holding the refrigerator
accessories inside and outside. Slide out and
remove the plastic or foam guard used to protect
the compressor from shipping
damage due to vibration and shock.
2.
Inspect and remove any remaining packaging, tape or printed materials
before powering on the refrigerator.
3.
Check to be sure you have all accessories and parts listed in the Parts and
Features section.
Proper Air Circulation
To ensure that your refrigerator
works at the maximum efficiency
it was
designed for, you should install it in a location where there is proper air
circulation,
plumbing and electrical
connections.
The following
are recommended
clearances around the refrigerator
:
Sides ...................3/4 inches (18mm)
Top ......................2 inches (50mm)
Back .................. 2 inches (50ram)
Electrical Requirements
Make sure there is a suitable power outlet (115 volts, 15 amps) with
proper grounding to power the refrigerator.
WARNING: Avoid the use of three prong adapters. NEVERcut of:[the
thirdgrounding prong in order to accommodate a two prong outlet. Cutting
off the grounding prong is a dangerous practice since it provides no effective
grounding for the refrigerator and may result in serious injury from electrical shock.
Installation
Your refrigerator
is designed for freestanding
installation ont4 It should not be
recessed or built-in. Place the refrigerator
on a floor strong enough to support it fully
loaded.
When moving the refrigerator,
never tilt it by more than a 45 degrees angle. This
could damage the compressor and the sealed system.
tf the refrigerator
has been tilted more than 45 degrees, let it stand in an upright
position for at least 24 hours prior to plugging it into the power source. This
will allow the refrigerant to settle and reduce the possibility of a malfunction in
the cooling system.
Plug the refrigerator
into an exclusive, properly installed grounded wall outlet.
Do not under any circumstances cut or remove the third (grounding) prong from
the power cord. And do not plug another appliance
into the same outlet as the
refrigeraton
See the WARNING
in Electrical
Requirements on the previous
page. Any questions concerning
power and/or grounding should be directed
toward a certified electrician
or a Sears or other qualified service dealer
After plugging the appliance
into a wall outlet, allow the unit to cool down for
24 hours(recommended)
before placing food into the refrigeraton
Installation
Limitations
Do not install your refrigerator
in any location
not properly
insulated or
heated, such as a garage, etc. Your refrigerator
was not designed to operate in temperature
settings below 55° Fahrenheit. Select a suitable location
for the refrigerator
on a hard
even surface away from direct sunlight or heat sources such as radiators, baseboard
heaters,
cooking appliances,
etc.
Leveling Feet
There are two leveling feet on the bottom of the unit near the unit front. Turnthe leveling
feet knobs to the left to raise the cabinet, and to the right to lower the cabinet.
4
6/8/10
