Tabla de contenido
Idiomas disponibles
Idiomas disponibles
D. Install the automatic shut-off valves on the washer shut-off valves
1. Remove the plastic protectors
from both ends of each
automatic shut-off valve.
Make sure the rubber o-rings
are seated properly (flat) inside
each shut-off valve hose fitting.
O-ring
seated flat
E. Screw the hoses onto each automatic shut-off valve
2. Match the red automatic shut-off
valve (HOT) to the red valve and
the blue (COLD) to the blue valve.
Shut-off
valve hose
fitting
Make sure each laundry hose still has its o-ring inside the hose fitting. If it
doesn't, use one of the extra o-rings provided in this package (if it already has
one, don't add another).
Make sure to match each hose to the shut-off valve it was on before. Then screw
each hose on tight by hand (use a channel lock or pliers for the last quarter-
turn).
3. Screw each hose fitting onto the
automatic shut-off valves.
Hand-tighten the collar of the
fitting onto the washer shut-off
valve. Keep the valve at a 4 o'clock
position until you're ready to give
the final tightening, then turn the
entire valve assembly to tighten
and straighten.
7
Tabla de contenido
