Antar AT52315 Manual De Usuario página 8

BACKREST ANGLE ADJUSTMENT
The carer should adjust the angle of the backrest according to the physical condition of the wheelchair user using the red levers located at the
handles. (Fig. 13 and Fig. 14)
FIG. 13 FIG. 14
Table assembly and disassembly
Once the wheelchair is unfolded, attach the table holders to the tubes on either side of the frame. Do not tighten the screws; screw the two
tubes into the corresponding holes in the table. (Fig. 15)
The table should then be slid into the latch hole and the screws tightened to the maximum. When lifting, the table should be pulled upwards
and lifted. (Fig. 16)
FIG. 15 FIG. 16
Brake user manual
The brakes must be applied each time you get into or out of the wheelchair. Hold the brake handle and move it forwards (unlocking) or
backwards (locking). Once locked, you can get in and out of the wheelchair.
NOTE: Please note that the brake should not be used when driving down a hill, as this may cause a risk of overturning. When using the
handbrake, hold the brake lever with both hands, tighten the grip to adjust the braking force or control the speed of the wheelchair.
NOTE: The wheelchair is also equipped with brakes for the carer.
Quick-folding backrest function
The fold-back function allows the wheelchair to be stored in narrow spaces. Press the handle with both hands and then tilt the push handles of
the wheelchair to fold. When opening the wheelchair, push the handles upwards until they lock.
PROBLEM SOLVING
Problem Control and problem solving
•
The condition of the wheels should be checked.
1. wheelchair changes •
Check the angle of the caster bracket
direction of travel
•
Please check that the rear wheels are evenly spaced from the
to the right or to the left
seat frame.
•
2. Reduced turning or
Check the tightness of the bolts and nuts.
driving speed •
Check that the wheel turns normally
•
3.Wheel problems -
Check the tightness of the bolts and nuts.
Wobbling •
Check the angle of the caster bracket.
4.Creaking and other - Check the tightness of the bolts and nuts. Inspect the wheel
disturbing sounds for rust or other defects.
- Check the tightness of the bolts and nuts.
5. wheelchair gaps
IU_AT52315