Makita XAD03 Manual De Instrucciones página 8

Screw the side grip on the tool securely. The side grip can be
installed on either side of the tool, whichever is convenient.
► 1. Side grip
Front handle
CAUTION:
Do not fix the front handle beyond the
limits of the arrow as illustrated. Be cautious that your
hand is not caught in the grip. Keep the hand away
from the drill chuck. They can lead to serious accidents.
CAUTION:
Always be sure that the hex bolts
(both sides) of the front handle are tightened securely.
The front handle can be installed in any position within
0° - 112.5° as illustrated.
1
► 1. Front handle
To change the position, loosen the hex bolts (both
sides) with a hex wrench and turn the front handle to the
desired position. Then tighten the hex bolts securely.
1
► 1. Front handle 2. Hex wrench
1
2
Installing or removing drill bit
To install the drill bit, place it in the chuck as far as it will
go. Tighten the chuck by hand. Place the chuck key in
each of the three holes and tighten clockwise. Be sure
to tighten all three chuck holes evenly.
To remove the drill bit, turn the chuck key counterclock-
wise in just one hole, then loosen the chuck by hand.
► 1. Chuck key
After use, return the chuck key to the storage cavity on
the tool as illustrated.
OPERATION
CAUTION:
Always insert the battery cartridge
all the way until it locks in place. If you can see the
red indicator on the upper side of the button, it is not
locked completely. Insert it fully until the red indicator
cannot be seen. If not, it may accidentally fall out of
the tool, causing injury to you or someone around
you.
CAUTION:
When the speed comes down
extremely, reduce the load or stop the tool to
avoid the tool damage.
CAUTION:
Hold the tool firmly when operat-
ing the tool.
8 ENGLISH
1