Cleaning And Maintenance - SOLAC DC7500 Instrucciones De Uso

Depiladora de cera
Ocultar thumbs Ver también para DC7500:
Tabla de contenido
Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 1
ankle to knee). Pull the strip back on itself, close
to the skin rather than away from it. (Fig. 4)
• To soothe the skin immediately after you
remove the strip, press the area with your hand.
• Use some used wax or oil to remove wax
traces. This wax doesn't come out with water,
soap or alcohol.
(Fig. 4)
11 Place the strips of used wax in the filter in tub
2 and set tub 2's temperature regulator to wax
melting mode (Fig. 1).
12 When the wax has melted, filter it, clean, then
remove the filter and place it under cold water.
13 If necessary, put back the temperature
regulator to the hair removal setting (Fig. 3).
You may continue hair removal by using
the wax in tub 2, then placing the used strips in
the filter which you have now placed into tub 1.
14 After hair removal, gradually top up the wax
with Solac wax capsules.
15 Set the two temperature regulators yo "stop"
(Fig. 2), and let the wax cool down before putting
away the appliance.
Using on your underarms(Fig. 5)
• Underarm hair tends to grow in two different
directions: the upper part grows upwards, and the
lower part downwards – so it will need to be
removed in two stages.
• Lift the elbow up and well back to tighten the
skin.
• Use the spatula to apply the wax.
• For the upper part of the underarm, apply the
wax in layers upwards towards the elbow. For the
lower part of the underarm, stroke the wax
downwards.
Using on your bikini line(Fig. 6)
• Only use on small areas at a time.
• Holding the skin taut, use the correct end of the
spatula to apply a layer of wax in the direction of
hair growth (generally towards the inner thigh).
Removal of downy facial hair (Fig. 7)
For the removal of superfluous facial
hair, use a very gentle touch.
For downy hair on the upper lip, pull
the wax strips in the direction of the
nose.
Skin care after waxing
• Skin may be slightly red after waxing. This is
normal, but bathing the area with cool water will
help to soothe.
• Apply baby oil. Baby oil helps you remove the
remaining wax and you will relieve some of the
pain. Any redness will fade in an hour
• If you feel a bit of irritation, don't scratch.
Instead, gently press your skin with your hand.
Any discomfort shouldn't last – if it does, see your
doctor.
• It is advisable to apply a tonic to dose the pores
and a good moisturizing cream after removing
hair.
• If you tend to get ingrown hairs, it helps to
exfoliate and moisturize your skin regularly.

4 CLEANING AND MAINTENANCE

• Before cleaning, ensure that the device is
unplugged.
• The appliance does not require any specific
maintenance.
• If occasionally, a little wax has run onto the
outer surface, you can easily remove it with your
finger nail.
Do not use a sharp object to remove
solidified wax or clean the pot.
• The pot doesn't require internal cleaning as any
remaining wax can be reheated for your next
waxing session.
- Do not clean the left over wax in the pot as the
pot is designed to reheat the remaining wax for
the next session.
Do not allow contact with or immerse the pot
in water. The wax is not water rinsable. Water
and soap will not clean the wax. Use some baby
oil.
The
appliance
horizontally.
• Never submerge the connector in water or any
other liquid or place it under running water
Cleaning the spatula after each use:
- Do not leave the spatula in the wax.
8
must
always
be
EN
stored
Tabla de contenido
loading

Este manual también es adecuado para:

Dc7502

Tabla de contenido