Idiomas disponibles
Idiomas disponibles
REF. 60035
EN
INSTRUCTION MANUAL
PRODUCT'S PRESENTATION
This LED working light has been designed to ensure a
perfect illumination of the working area and any other
place. Its operation with the portable lithium battery
makes it ideal to move it freely all over the workplace,
as well as in situations when there is no access to the
electrical power supply.
The LED light lens provides an output which can be ad-
justed to 500 and 1000 lumens, and the work light head
features a 90º adjustment angle to adapt the direction
of the light bulb as appropriate. It also includes a soft
grip handle for a better control and comfort, and a utility
hook to attach it to any object.
SAFETY INSTRUCTIONS
• Check for breakage of parts, damage to switches
and any other conditions that may affect its ope-
ration.
• Disconnect the battery from the tool and place the
switch in the locked or off position before making
any adjustments, changing accessories, or storing
the tool.
• Keep the working area clean and well illuminated.
• Do not operate the tool in the presence of flam-
mable liquids, gases, or dust.
• Keep children and non-authorized people away
from the tool while in use.
• Do not operate the tool if you get tired easily or un-
der the influence of drugs, alcohol or medication.
• Dress properly. Do not wear loose clothing or
jewelry and contain long hair.
• Remove adjusting keys or wrenches before tur-
ning the tool on.
• Use safety equipment. Always wear safety glas-
ses and use a dust mask, non-skid safety shoes,
safety helmet or hearing protection when neces-
sary.
• Do not use the tool if the switch does not longer
work and repair it immediately.
• Store the tool out of reach of the children while
not in use.
• Do not expose the tool to rain or wet conditions.
• Do not modify or open the work light in any case,
all electronic parts are fixed already.
• You must change a cracked glass before using the
work light again.
OPERATION
Adjusting the light direction
This led work light has an angle adjustment of 90º. The
lamp head can be swiveled in any direction:
Switching On/Off
This led work light has an On/Off switch that can also
be used to adjust the LED work light brightness:
1. Press once (x1) to turn the light on in its low mode
(500 lm)
2. Press twice (x2) to turn the light on in its high
mode (1000 lm)
3. Press a third time (x3) to set the light in its flashing
mode.
4. Press four times (x4) to turn the light off.
NOTE! Do not stare directly at the light beam or point
the beam at any person.
MAINTENANCE
• Always be sure that the tool is switched off and
the battery pack is removed from the tool before
attempting to perform inspection or maintenance.
• Do not use cleaning agents to clean the plastic
parts of the tool, a mild detergent on a damp cloth
is recommended instead.
• The light source cannot be replaced. If the light
source is defective, the entire work light has to be
replaced.
• Tool, accessories and packaging should be sorted
for environment-friendly recycling.
• Keep the vents clean. Clean all parts of the tool,
clean dust periodically.
· 5 ·
