EN GARANTIE
1. WARNING
To avoid any risk of toppling of the island, the product must be
securely attached to the Ìoor. Check the suitability and the strength
of the Ìoor to ensure that the Ìoor can bear the load of the product
and withstand the forces put on the securing elements. Improper
installation can result in the product falling and cause serious
injuries to people. In case of a doubt regarding the installation,
ask for advice from a specialised sales assistant or contact a
professional.
*Use screws, washers and plugs suited to the type of material of
your Ìoor. These are not included. To obtain advice on the screws
and fittings suited to your Ìoor, ask a specialised sales assistant.
2. BEFORE SETUP
Make sure that all the parts and screws have been included in the
package before starting the setup. Check to make sure that all the
components are in good condition before starting setup.
3. SETUP
Setup must be carried out by qualified individuals. Safety rules
must be observed throughout the setup operation, with the
major risk being falls (loss of balance, slipping...). Keep children
away. Wear suitable personal protective equipment (PPE). Follow
closely the setup instructions and tool recommendations. Failure
to comply with these instructions may result in body injuries, or
seriously endangering the lives of users. Instructions must be
kept for the whole duration of the product lifetime. They will be
requested for after-sales service where you will need to provide
part numbers as indicated in the parts listing.
4. MAINTENANCE
Check the resistance of the wall and floor fasteners over time.
Make sure that the assembled parts are tightly held together, and
that they are not in a deteriorated condition.
Check to make sure that the components are in good condition. Fix
or replace deteriorated components.
Every three months, clean your product using fresh water to
preserve your product's look and its resistance to corrosion. Do
not use corrosive agents.
Do not hang any objects on these products.
5. WARRANTY CAUSE
Not for use in seaside areas.
5.1 TERMS AND CONDITIONS OF THE
ADEO SERVICES MANUFACTURER
WARRANTY
•
The scope of the Adeo Services manufacturer warranty:
Adeo Services products are designed and built to provide qu ality
performance for normal use. If a product proves to be defective
during the warranty period under normal use, it is Adeo Services'
responsibility to repair or replace it.The Adeo Services warranty
covers the repair or replacement (at the discretion of Adeo Services)
of your device marketed by Adeo Services if it proves to be defective
due to a material or manufacturing defect during the warranty
period. In case of unavailability of a part required for proper
functioning of the product, Adeo Services commits to replacing it
with a part of equivalent characteristics and performance levels The
rights under the legal warranties provided by the civi l code and the
consumer code.
•
Cases excluded from the coverage of the Adeo Services
manufacturer warranty:
The Adeo Services manufacturer warranty is not intended to apply in
the cases listed below:
- Indoor and outdoor use within 5km of the sea and sand.
- Normal wear and tear of the product and/or its components.
- Accidental damage (due to dropping the product, impact or
improper installation of the product)
- Damage resulting from use that does not comply with the
information in the user manual and/or packaging (e.g. incorrect
power supply voltage)
- Damage caused by failure to comply with the product maintenance
recommendations.
- Damage caused by external sources such as transportation,
weather, power failure or power surges.
broken plastic components,
20