4
Install the Monitor onto the Monitor Arm
Carefully place the Monitor on a protective/soft surface
1.
with the VESA Mounting Points at the back of the Monitor
facing Up.
Remove any pre-installed hardware at the VESA Mounting
2.
Points (e.g. screws or covers) at the back of the Monitor.
Consult the Monitor's Manual and remove them as
instructed.
Note: Ensure you only remove the screws (x 4) of the VESA
Mounting Points. Do not remove any of the screws of the
Monitor's structural assembly.
Warning! Do not overtighten the screws. If you encounter
resistance while tightening the screws, stop tightening.
Failure to do so could result in damage to the Monitor.
To view manuals, videos, drivers, downloads, technical drawings, and more visit www.startech.com/support
Note: Repeat Steps 1 - 4 to install
the second Mounting Plate.
19
