Maintenance And Troubleshooting; Maintenance; Troubleshooting; Scrap - Erreka NAOS NASR70E Manual Del Instalador

MAINTENANCE AND TROUBLESHOOTING

1

MAINTENANCE


This operator does not require any special care. However, it is necessary to carry out the following checks every
6 months:

Disconnect the unit from the power supply
before carrying out
operation.
1 Frequently check the facility in order to discover any
imbalance or sign of deterioration or wear. Do not
use the device if any repair or adjustment is
necessary.
2

TROUBLESHOOTING

Problem
The operator does not make
a n y m o v e m e n t w h e n t h e
opening or closing controls are
activated
Defective operator operation
The door does not close
The door cannot completely
close (or open)
Loud noise during operation
The operator works when
pressing the wall pushbutton
or control panel buttons, but
n o t w h e n a c t i v a t i n g t h e
remote control
3

SCRAP


The operator, up until the end of its useful life,
must be dismounted at its location by an
installer who is as well qualified as the person
who completed the assembly, observing the
same precautions and safety measures. This
will avoid possible accidents and damage to
adjacent facilities.
any maintenance
Cause
Absence of system power supply
Electrical installation defective
Internal power plate fuse
Programming has changed due to
strong environmental disturbances
(voltage alterations, magnetic fields,
etc.)
The photocell circuit is open
The resistance of the door has increased
when closing (or when opening)
The force of the operator during closing
(or opening) is too low
The assembly or length of the arms is
inappropriate
Opening stopper incorrectly adjusted
Chain not taut
The track, attachments or operator are
poorly fastened or assembled
The remote control radio code is not
programmed in the operator
The remote control batteries are flat
2 Clean and lubricate the joints and tracks of the
installation, so as not to increase the effort of the
operator.
3 Check that the controls and photocells, as well as
their installation, have not suffered any damage
from the weather or external agents.
4 Check unlocking can be carried out easily.
Solution
Restore the power supply
Check that the installation does not
have any short-circuits or cut-offs
Check the fuse
Programme the operator again
Check the circuit
Check the moving parts of the door
and remove the resistance
Programme the opening and closing
forces again
Check the length and assembly of the
arms after closing the door
Adjust the opening stopper correctly
and reprogramme the opening and
closing positions
Tighten the chain properly
Check the assembly and installation
levels
Correctly programme the radio code
Replace the batteries
}
The operator must be deposited in the appropriate
containers for subsequent recycling, separating and
classifying of the different materials in line with their
nature. NEVER deposit it in domestic rubbish or in
landfills which are not suitably controlled, as this will
cause environmental contamination.
NAOS garage door opener operator
English
63