Idiomas disponibles
Idiomas disponibles
ASSEMBLY
Step by step
03
11#
9#
4#
12#
5#
Attach the side cover to the
04
standpipe and base frame
with flat washers E#M8 (4
pcs.), D#M8*16 (4 pcs.).
6#
Place the base frame side tube on
the base frame in the direction of
the arrow and fasten the half round
head hex bolts F# (4), hex lock nuts
G# (4) and flat washers E# (4) on
the base frame, then secure the
base frame side tube and base
frame with hex screws J# (2) and
flat washers E# (2), and insert the
pins K# from the bottom of the
column into the holes in the sheet
iron at the front end of the work
table (as shown in the figure).
6#
8#
8#
05
Before use: press the start button while the electronic clock is turned on, the treadmill will start running.
NOTE! The safety key must be placed in the position of the yellow sticker in the center of the meter, the
If the electronic clock window shows "E07", the safety key is not in place or is not in place. not in place or
is not in place.
Emergency stop function: when the safety key is off, the power cable is disconnected and the weak part
maintains power. Operation is not software controlled.
For your safety, be sure to use the safety key during the training exercise.
Please note:Tighten all screws after confirming that all screws are installed according to the above
requirements, and check for omissions before connecting to the power cable.
You now have your MC-100 ready to use!
18
Safety key:
Insert the key into the slot
EN - MC-100
