CAT MATE 335 Instrucciones página 2

INSTRUCTIONS
IMPORTANT SAFETY
INSTRUCTIONS
When using electrical appliances,
basic safety precautions should
always be followed to reduce the
risk of fire, electric shock and/
or injury to persons, including the
following:
• Read and follow all instructions that
are on the product or provided with
the product.
• Register your purchase on-line at
www.pet-mate.com
(see guarantee).
• Check that the voltage label on the
transformer (I) conforms with your
supply voltage.
• Inspect product regularly for correct
operation and damage. Do not use if
in doubt.
• This product is designed for use
with pets only, as described in these
instructions.
• Close supervision is necessary when
an appliance is used near children.
• Do not use outdoors. FOR INDOOR
USE ONLY.
• Do not let pump run dry.
• Turn off power and unplug
transformer (I) with dry hands before
disassembling pet fountain or
cleaning.
• Turn off power and unplug
transformer (I) if power cord/
plugs are damaged or fountain
malfunctions.
• Do not use in a bathroom.
• Do not allow electrical connector or
transformer (I) to become wet.
• Do not allow pets or children to
tamper with product.
• Do not use an extension cord.
• Ensure transformer (I) is in a well
ventilated position away from
curtains or other flammable items.
• Transformer (I) is intended to be
correctly orientated in a vertical or
floor mount position.
• Appliance is placed on a flat, even
surface.
• Do not leave appliance unattended
for extended periods.
• Do not allow pets to chew or
swallow any parts.
• Dispose of all packaging material
properly.
NOTE: Plastic bags could cause
suffocation - keep away from children
and animals.
SAVE THESE INSTRUCTIONS
1
A
D
Y X
5
G
A. ASSEMBLY
1. Remove upper bowl moulding (A) as shown in Fig. 1 and adjust flow rate (Fig. 2) as
required.
NOTE: An intermediate flow is recommended. Lower flows will give less water
loss through evaporation. Higher flows will cool the water more and may be more
appealing to your pet.
2. Remove filter cartridge (B) from packaging and rinse under a tap to remove any
charcoal dust. Insert filter cartridge (B) as shown in Fig. 1.
3. Replace upper bowl moulding (A) taking care to ensure it is fully seated. Fill lower
bowl (C) with water up to 'MAX' mark (X, Fig. 1). Connect transformer (E) to pump
(D) and plug into power supply.
4. After a short period, water should start flowing. You may top up main bowl (C) to
'MAX' mark (X, Fig. 1) using a jug as required.
WHEN IN USE, DO NOT LET THE WATER LEVEL FALL BELOW 'MIN' MARK
(Y, Fig. 1).
E
B
C
H
I
2
D
3
A
D
F
4
G
D
J D