Idiomas disponibles
Idiomas disponibles
Programming
Your garage door opener has been programmed at the factory to operate with your remote control. The remote control can be
programmed using the door control or the garage door opener. To program additional remote controls refer to the instructions provided
with the additional remote controls.
PROGRAMA REMOTEUSINGTHE LEARNBUTTON
TO ADD, REPROGRAM,ORCHANGE A REMOTECONTROL/
KEYLESS ENTRYPIN USINGTHE SMART CONTROLPANEL
1. Press and releasethe Learn
button on the garage door opener. The
Learn indicator light will glow steadily
for 30 seconds.
2. Within 30 seconds, press and hold the
button on the remote control.
1. Press the navigation button below
"MENU"to view the Featuresmenu.
2. Use the navigation buttons to scroll to
"PROGRAM" and press the navigation
button under _
to continue.
3. Releasethe button when the garage
door opener light blinks. It has learned
the code. If light bulbs are not installed,
two clicks will be heard.
When replacing the light lens cover, ensure the antenna wires are
hanging straight down.
3. Select "REMOTE" o r "KEYPAD" to
program from the program menu.
Press_
to continue.
4. Press the button on the remote
control that you wish to operate your
garage door.
OR
Enter a 4-digit personal identification
number (PIN) of your choice on the
keyless entry keypad.Then press the
ENTERbutton.
OR
?
?
?
?
PIN
To Erase the Memory
ERASE ALL REMOTECONTROLS AND KEYLESS ENTRIES
1. Press and hold the learn button on garage door opener until the
learn LEDgoes out (approximately 6 seconds). All remote
control and keyless entry codes are now erased.
Reprogram any accessory you wish to use.
ERASEALLDEVICES
1. Press and hold the learn button on garage door opener until the
learn LEDgoes out (approximately 6 seconds).
2. Immediately press and hold the learn button again until the
learn LEDgoes out. All codes are now erased.
Reprogram any accessoryyou wish to use.
34
